消失模铸造空心凸轮轴充型过程中热平衡计算

张元好

浏览量 : 0 下载量: 44 CSCD: 1

导出
分享
收藏
专辑

消失模铸造空心凸轮轴充型过程中热平衡计算
Calculation of Heat Balance during Mold Filling for Hollow Camshaft in EPC
2003年第1期页码：61-63
纸质出版日期： 2003 ，
DOI：

扫描看全文

[1]张元好.消失模铸造空心凸轮轴充型过程中热平衡计算[J].特种铸造及有色合金,2003(01):61-63+0.

Zhang Yuanhao. Calculation of Heat Balance during Mold Filling for Hollow Camshaft in EPC[J]. Special Casting & Nonferrous Alloys, 2003,(1):61-63.
[1]张元好.消失模铸造空心凸轮轴充型过程中热平衡计算[J].特种铸造及有色合金,2003(01):61-63+0. DOI：

Zhang Yuanhao. Calculation of Heat Balance during Mold Filling for Hollow Camshaft in EPC[J]. Special Casting & Nonferrous Alloys, 2003,(1):61-63. DOI：

摘要

试验测得消失模铸造空心凸轮轴充型过程的温度场

对其热量分布进行了计算。计算结果表明

金属液充型过程中热量主要损失于使砂型和钢管加热

采用薄壁钢管、提高浇注温度可以解决空心凸轮轴浇不足缺陷

与试验验证结果一致。

Abstract

Calculation of heat distribution was conducted for hollow camshaft based on experimentally measuring temperature field during mold filling in EPC. The results showed that main loss of heat in mold filling was used to heat sand mold and steel pipe. Misrun in hollow camshaft can be avoided by adopting steel pipe with thin wall and increasing pouring temperature

which was identical with the experimental verification.