铝合金挤压铸造若干技术问题的讨论

唐多光; 徐张翼; 沈友良

浏览量 : 0 下载量: 335 CSCD: 11

导出
分享
收藏
专辑

铝合金挤压铸造若干技术问题的讨论
Discussion on Some Technological Aspects for Aluminum Alloy in Squeeze Casting
2002年第6期页码：28-29
纸质出版日期： 2002 ，
DOI：

扫描看全文

[1]唐多光,,,,,,,,,,徐张翼,沈友良.铝合金挤压铸造若干技术问题的讨论[J].特种铸造及有色合金,2002(06):28-29+1.

Tang Duoguang. Discussion on Some Technological Aspects for Aluminum Alloy in Squeeze Casting[J]. Special Casting & Nonferrous Alloys, 2002,(6):28-29.
[1]唐多光,,,,,,,,,,徐张翼,沈友良.铝合金挤压铸造若干技术问题的讨论[J].特种铸造及有色合金,2002(06):28-29+1. DOI：

Tang Duoguang. Discussion on Some Technological Aspects for Aluminum Alloy in Squeeze Casting[J]. Special Casting & Nonferrous Alloys, 2002,(6):28-29. DOI：

摘要

叙述了挤压铸造的基本特点

对液态挤压铸造机要求具备低流速大流量平稳充填铸型和瞬时增压的能力。参考国内用油压机作挤压铸造机的设备和对由此所产生的铸件缺陷作了具体分析

并对我国挤压铸造今后的发展提出了一些建议

Abstract

The basic features of the squeeze casting were described. The squeeze casting machine should possess the ability of smooth mold filling with low flow speed and large discharge quantity and increasing the squeezing pressure instantaneously. The details of oil press used as squeeze casting machine in China and thereby the casting defects were analyzed. Some comments on the future development of the squeeze casting in China were suggested.