挤压铸造原理及缺陷分析

唐多光; 张金龙; 徐张翼; 沈友良; 程黔国

浏览量 : 0 下载量: 719 CSCD: 12

导出
分享
收藏
专辑

挤压铸造原理及缺陷分析
Principle of Squeezing Casting and Analysis of Casting Defects
2003年第1期页码：43-45
纸质出版日期： 2003 ，
DOI：

扫描看全文

[1]唐多光,张金龙,徐张翼,沈友良,程黔国.挤压铸造原理及缺陷分析[J].特种铸造及有色合金,2003(01):43-45+1.

Tang Duoguang Zhang Jinlong. Principle of Squeezing Casting and Analysis of Casting Defects[J]. Special Casting & Nonferrous Alloys, 2003,(1):43-45.
[1]唐多光,张金龙,徐张翼,沈友良,程黔国.挤压铸造原理及缺陷分析[J].特种铸造及有色合金,2003(01):43-45+1. DOI：

Tang Duoguang Zhang Jinlong. Principle of Squeezing Casting and Analysis of Casting Defects[J]. Special Casting & Nonferrous Alloys, 2003,(1):43-45. DOI：

摘要

论述了以低速、大流量、平稳充填铸型并在瞬间及时增压是挤压铸造的基本原理。分析了实际铸造比压偏小以及不能瞬间及时增压是造成摩托车车轮挤压铸件表面起泡和冷隔的主要原因。为防止挤压铸造铸件缩裂、缩孔产生和提高铸造比压

推荐一种合理料缸（压室）设计。

Abstract

Mold filling smoothly with low speed and large flow rate as well as instant pressurization in time conformed to the basic principles of squeezing casting.The lower specific pressure and delay pressurization in time during casting process were responsible for surface blister and cold shut of motor cycle wheel in squeezing casting. An available chamber design is presented to prevent squeezing casting from creation of shrinkage crack and shrinkage hole as well as to elevate specific pressure.