消失模铸造碳钢件内部增碳的研究

葛毓立; 李玉光; 胥文杰

浏览量 : 0 下载量: 102 CSCD: 1

导出
分享
收藏
专辑

消失模铸造碳钢件内部增碳的研究
Carburization in Carbon Steel Castings in EPC
2004年第1期页码：62-63
纸质出版日期： 2004 ，
DOI：

扫描看全文

[1]葛毓立,,,,,,,,,李玉光,,,,,,,,,胥文杰.消失模铸造碳钢件内部增碳的研究[J].特种铸造及有色合金,2004(01):62-63+88.

Ge Yuli Li Yuguang. Carburization in Carbon Steel Castings in EPC[J]. Special Casting & Nonferrous Alloys, 2004,(1):62-63.
[1]葛毓立,,,,,,,,,李玉光,,,,,,,,,胥文杰.消失模铸造碳钢件内部增碳的研究[J].特种铸造及有色合金,2004(01):62-63+88. DOI：

Ge Yuli Li Yuguang. Carburization in Carbon Steel Castings in EPC[J]. Special Casting & Nonferrous Alloys, 2004,(1):62-63. DOI：

摘要

用EPS做模型

干砂造型在负压的状态下浇注碳钢

系统研究影响各种工艺条件下EPC法生产碳钢件内部增碳的因素。发现模型分别用石英粉、刚玉粉、锆英粉 3种涂料涂覆

浇注碳钢件均有内部增碳现象发生

其中使用石英粉涂料的铸件内部增碳较小

采用底注式浇注

同一铸件随着铸件高度的增加

内部增碳增加。另外

随真空度的增加内部增碳减小。

Abstract

The EPS pattern is used for carbon steel castings in drying sand mould under negative pressure. The factors influencing carburization in carbon steel castings under various processing conditions in EPC were studied systematically.It was found that carburization in carbon steel casting occured using silica flour

alumina powder and zirconium powder coatings

of which less carburization appeared with silica flour coating.The carburization increased with casting height increase in bottom pouring.In addition

the carburization decreased with vacuum rate increase.