新型复杂铝青铜Cu-14Al摩擦磨损特性的研究

金玉花; 路阳; 王智平; 李文生; 徐建林

浏览量 : 0 下载量: 132 CSCD: 5

导出
分享
收藏
专辑

新型复杂铝青铜Cu-14Al摩擦磨损特性的研究
Anti-Frictional Characteristic of New Complex Al-bronze Cu14Al
2004年第3期页码：32-33
纸质出版日期： 2004 ，
DOI：

扫描看全文

[1]金玉花,路阳,王智平,李文生,徐建林.新型复杂铝青铜Cu-14Al摩擦磨损特性的研究[J].特种铸造及有色合金,2004(03):32-33+74.

Jin Yuhua Lu Yang Wang Zhiping Li Wensheng Xu Jianlin. Anti-Frictional Characteristic of New Complex Al-bronze Cu14Al[J]. Special Casting & Nonferrous Alloys, 2004,(3):32-33.
[1]金玉花,路阳,王智平,李文生,徐建林.新型复杂铝青铜Cu-14Al摩擦磨损特性的研究[J].特种铸造及有色合金,2004(03):32-33+74. DOI：

Jin Yuhua Lu Yang Wang Zhiping Li Wensheng Xu Jianlin. Anti-Frictional Characteristic of New Complex Al-bronze Cu14Al[J]. Special Casting & Nonferrous Alloys, 2004,(3):32-33. DOI：

摘要

对高铝青铜Cu 14Al的铸态组织在干摩擦和油润滑两种状态下

及高铝青铜Cu 14Al热处理前后油润滑下

进行摩擦磨损对比试验。结果表明

高铝青铜Cu 14Al不适合在干摩擦条件下使用

加 2 0 #润滑油后

其他条件不变

摩擦因素由 0 .5 2 6～ 0 .684下降为 0 .13 8～ 0 .161

磨损质量损失降为干摩擦下的 3 .7%左右

对铸态组织在 860～ 90 0℃固溶处理和 5 60～ 60 0℃时效处理后

与铸态时相比

摩擦因素由 0 .13 8～ 0 .161下降为 0 .0 2 2～ 0 .0 3 8

磨损质量损失下降为铸态油润滑下的 40 %左右。

Abstract

As-cast structure of high Al-bronze were compared under dry friction with under oil-lubricant friction. Also anti-frictional characteristics of as-cast and heat treated Al-bronze Cu14Al were compared under oil-lubricant condition.The results showed that high Al bronze Cu14Alx was un-suitable for dry friction. Under oil lubricant condition the friction coefficient decreased from 0.526～0.684 to 0.138～0.161 and wear mass-loss decreased up to about 3.7% of that under dry friction.Frictional coefficient of solid solution treated alloy at 860～900 ℃ with ageing at 560～ 600 ℃ decreased from 0.138～0.161 to 0.022～0.038 and frictional mass-loss decreased up to about 40% compared with that of as-cast alloy under oil lubricated condition.