TiN/Ti复合材料的熔铸法制备及微观组织

李俊刚; 尹冬松; 金云学

浏览量 : 0 下载量: 161 CSCD: 1

导出
分享
收藏
专辑

TiN/Ti复合材料的熔铸法制备及微观组织
Preparation and Microstructure of TiN/Ti Composites in Smelting-casting
2005年第5期页码：319-320
纸质出版日期： 2005 ，
DOI：

扫描看全文

[1]李俊刚,尹冬松,金云学.TiN/Ti复合材料的熔铸法制备及微观组织[J].特种铸造及有色合金,2005(05):319-320+256.

Li Jungang 1 Yin Dongsong 2 Jin Yunxue 3. Preparation and Microstructure of TiN/Ti Composites in Smelting-casting[J]. Special Casting & Nonferrous Alloys, 2005,(5):319-320.
[1]李俊刚,尹冬松,金云学.TiN/Ti复合材料的熔铸法制备及微观组织[J].特种铸造及有色合金,2005(05):319-320+256. DOI：

Li Jungang 1 Yin Dongsong 2 Jin Yunxue 3. Preparation and Microstructure of TiN/Ti Composites in Smelting-casting[J]. Special Casting & Nonferrous Alloys, 2005,(5):319-320. DOI：

摘要

用熔铸法制备了TiN/Ti复合材料

并用SEM和XRD研究复合材料的微观组织和相组成

分析了TiN的形成过程。结果表明

所制备的复合材料增强相分布均匀

成麦穗状连续线状分布。对其SEM照片的研究表明

TiN形态为尖角小片状、片状或块状

颗粒大小在2～8μm

TiN颗粒与基体界面干净

无反应层。

Abstract

SEM and XRD were employed to observe microstructure and phase constituent of TiN/Ti composites prepared by the smelting-casting method.The formation of TiN was analyzed.The results showed that continuous chain-like enhancement phase in the composites was uniformly distributed.SEM observation revealed that the morphology of TiN with the grain size of 2～8 μm is sharp angle sheet shape

sheet or bulk shape.There is no reacted layer between TiN particle and matrix interface.