冷轧变形铝锡复合材料的再结晶

崔国明; 曾建民; 何国强; 郑进城

复合材料 | 浏览量 : 0 下载量: 106 CSCD: 0

导出
分享
收藏
专辑

冷轧变形铝锡复合材料的再结晶
Investigation on Re-crystallization of Cold Rolled Al-Sn Composite
2007年第S1期页码：176-178
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]崔国明,曾建民,何国强,郑进城.冷轧变形铝锡复合材料的再结晶[J].特种铸造及有色合金,2007(S1):176-178.

Cui Guoming Zeng Jianmin He Guoqiang Zheng Jincheng. Investigation on Re-crystallization of Cold Rolled Al-Sn Composite[J]. Special Casting & Nonferrous Alloys, 2007,(S1):176-178.
[1]崔国明,曾建民,何国强,郑进城.冷轧变形铝锡复合材料的再结晶[J].特种铸造及有色合金,2007(S1):176-178. DOI：

Cui Guoming Zeng Jianmin He Guoqiang Zheng Jincheng. Investigation on Re-crystallization of Cold Rolled Al-Sn Composite[J]. Special Casting & Nonferrous Alloys, 2007,(S1):176-178. DOI：

摘要

基于冷轧变形铝锡合金再结晶过程中硬度变化的敏感性

比较研究了Al-10Sn和Al-10Sn/TiB2复合轴瓦材料的再结晶动力学。通过硬度-时间软化曲线

计算了两种材料的再结晶激活能

比较了两种材料的再结晶组织。结果表明

硼化钛颗粒的存在提高了材料再结晶温度约50℃

使材料的热稳定性提高。Al-10Sn和Al-10Sn/TiB2的再结晶激活能分别为83.16kJ/mol和92.98kJ/mol。

Abstract

Re-crystallization dynamics of bearing materials of Al-10Sn and Al-10Sn/TiB2 were investigated based on the sensitiveness in hardness of the materials during re-crystallization.Re-crystallizationactivation energyof the materials were calculated through hardness vs.time curves

and microstructures of the re-crystallization for the two materials were compared by means of metallography.The results indicate that the existence of TiB2particles increases the re-crystallization temperature by up to 50 ℃

that is to say

increasing the stabilization in elevated temperature.Re-crystallizationactivation energyof Al-10Sn and Al-10Sn/TiB2 are 83.16 kJ/mol and 92.98 kJ.mol

respectively.