大型齿轮圈铸造工艺优化

庞富伟; 王爱琴; 谢敬佩; 梁志宁

计算机应用技术 | 浏览量 : 0 下载量: 105 CSCD: 1

导出
分享
收藏
专辑

大型齿轮圈铸造工艺优化
Process Optimization for Large Gear Ring
2008年第S1期页码：543-545
纸质出版日期： 2008 ，
DOI：

扫描看全文

[1]庞富伟,王爱琴,谢敬佩,梁志宁.大型齿轮圈铸造工艺优化[J].特种铸造及有色合金,2008(S1):543-545.

Pang Fuwei Wang Alqin Xie Jingpei Liang zhining. Process Optimization for Large Gear Ring[J]. Special Casting & Nonferrous Alloys, 2008,(S1):543-545.
[1]庞富伟,王爱琴,谢敬佩,梁志宁.大型齿轮圈铸造工艺优化[J].特种铸造及有色合金,2008(S1):543-545. DOI：

Pang Fuwei Wang Alqin Xie Jingpei Liang zhining. Process Optimization for Large Gear Ring[J]. Special Casting & Nonferrous Alloys, 2008,(S1):543-545. DOI：

摘要

利用华铸CAE软件

对大型齿轮圈铸钢件进行了凝固过程的数值模拟

发现了缩孔、缩松缺陷产生的部位

在此基础上对其铸造工艺进行了优化

然后对模拟结果进行了分析与比较。结果表明:合理设置保温冒口、冷铁的大小和位置

加上合适的冒口套

可以保证铸件顺序凝固和金属液的有效补缩

获得结构完整、没有缺陷的铸钢件。

Abstract

The temperature field of the solidification simulation for the large gear ring castings has been made with HUA ZHU CAE software

the position of shrinkage is watched

Based on this

the design of these castings has been optimized

then

analyzing and compare the simulation result. the result shows that the size and placement of the insulated riser and iron chill are intercalated reasonably could promise castings direct solidification and lengthen feeding direction of metal liquid. To obtain the castings of structure completely and no flaw.