3102合金翅片铝箔铸轧过程的晶粒变化与控制

蒋显全; 李宁; 张秀锦; 江茂华

浏览量 : 0 下载量: 230 CSCD: 2

导出
分享
收藏
专辑

3102合金翅片铝箔铸轧过程的晶粒变化与控制
Grain Size Change and Control of 3102 Aluminum Alloy Foils Fin during Casting-rolling Process
2006年第7期页码：454-456
纸质出版日期： 2006 ，
DOI：

扫描看全文

[1]蒋显全,李宁,张秀锦,江茂华.3102合金翅片铝箔铸轧过程的晶粒变化与控制[J].特种铸造及有色合金,2006(07):454-456+392.

Jiang Xianquan~ 1, 2, Li Ning~1, et al. Grain Size Change and Control of 3102 Aluminum Alloy Foils Fin during Casting-rolling Process[J]. Special Casting & Nonferrous Alloys, 2006,(7):454-456.
[1]蒋显全,李宁,张秀锦,江茂华.3102合金翅片铝箔铸轧过程的晶粒变化与控制[J].特种铸造及有色合金,2006(07):454-456+392. DOI：

Jiang Xianquan~ 1, 2, Li Ning~1, et al. Grain Size Change and Control of 3102 Aluminum Alloy Foils Fin during Casting-rolling Process[J]. Special Casting & Nonferrous Alloys, 2006,(7):454-456. DOI：

摘要

研究了Al-5Ti-1B晶粒细化剂添加方式和添加量对3102合金铝箔铸轧坯料晶粒大小的影响。结果表明:当Ti含量（质量分数

下同）为0.03%

.06%

其中以丝状形式加入量在0.01%以上

其余以块状形式加入时

可得到晶粒尺寸在0.1mm以下、晶粒大小分布均匀的3102铸轧坯料。另外还分析和论述了控制3102铸轧坯料晶粒粗大应采取的操作技术措施和最佳工艺参数。

Abstract

Effects of adding ways and addition of Al-5Ti-B master alloy on grain size of 3102 aluminum foils in casting-rolling process are investigated. The results show that the 3102 aluminum alloy billets with uniformly distributed grain below 0.1mm in size can be prepared by adding Ti content of 0.03%

0.06%

where silk-like Ti addition is over 0.01%

the other is bulky. The operation and optimized processing parameters of controlling coarse grain in 3102 aluminum billet are approached.