金属型铸造ZA50合金的力学性能和组织

程巨强

浏览量 : 0 下载量: 191 CSCD: 4

导出
分享
收藏
专辑

金属型铸造ZA50合金的力学性能和组织
Mechanical Properties and Microstructure of Zn-50Al Alloy in Permanent Mold Casting
2006年第7期页码：452-454
纸质出版日期： 2006 ，
DOI：

扫描看全文

[1]程巨强.金属型铸造ZA50合金的力学性能和组织[J].特种铸造及有色合金,2006(07):452-454+392.

Cheng Juqiang. Mechanical Properties and Microstructure of Zn-50Al Alloy in Permanent Mold Casting[J]. Special Casting & Nonferrous Alloys, 2006,(7):452-454.
[1]程巨强.金属型铸造ZA50合金的力学性能和组织[J].特种铸造及有色合金,2006(07):452-454+392. DOI：

Cheng Juqiang. Mechanical Properties and Microstructure of Zn-50Al Alloy in Permanent Mold Casting[J]. Special Casting & Nonferrous Alloys, 2006,(7):452-454. DOI：

摘要

研究了金属型铸造Zn-50Al（ZA50）高强度铸造耐磨合金的组织和力学性能。结果表明

ZA50合金金属型铸态组织为α相和（α+η）共析组织及合金化合物

抗拉强度（σb）可达477MPa

金属型铸造+200℃时效处理的组织为α相和粒状（α+η）共析组织及合金化合物

抗拉强度（σb）可达354MPa

ZA50合金比ZA27合金有更高的强度和断裂韧度。分析了合金元素形成的化合物在ZA50合金中的形貌特征。

Abstract

Microstructure and mechanical properties of Zn-50Al （ZA50） alloy in permanent mold casting were investigated. The results show that as-cast microstructure of the ZA50 alloy with tensile strength of 477 MPa in permanent mold casting is composed of α phase

（α+η）eutectoid structure and intermetallic compound

while microstructure of the alloy after aged at 200 ℃ is composed of α phase

particle （α+η）eutectoid structure and intermetallic compound

and its tensile strength reaches 354 MPa. The strength and ductility of ZA50 alloy are higher than those of ZA27 alloy. The morphology of formed intermetallic compound in ZA50 alloy was analyzed also.