6063铝合金热变形行为的研究

左秀荣; 樊彬彬; 仲志国; 吴欣凤; 李广钦; 崔海超; 孙海斌

专利文献信息 | 浏览量 : 0 下载量: 577 CSCD: 1

导出
分享
收藏
专辑

6063铝合金热变形行为的研究
Thermal Deformation of 6063 Aluminum Alloy
2007年第1期页码：19-21
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]左秀荣,樊彬彬,仲志国,吴欣凤,李广钦,崔海超,孙海斌.6063铝合金热变形行为的研究[J].特种铸造及有色合金,2007(01):19-21+8.

Zuo Xiurong~1, Fan Binbin~1, Zhong Zhiguo~1, et al. Thermal Deformation of 6063 Aluminum Alloy[J]. Special Casting & Nonferrous Alloys, 2007,(1):19-21.
[1]左秀荣,樊彬彬,仲志国,吴欣凤,李广钦,崔海超,孙海斌.6063铝合金热变形行为的研究[J].特种铸造及有色合金,2007(01):19-21+8. DOI：

Zuo Xiurong~1, Fan Binbin~1, Zhong Zhiguo~1, et al. Thermal Deformation of 6063 Aluminum Alloy[J]. Special Casting & Nonferrous Alloys, 2007,(1):19-21. DOI：

摘要

采用Gleeble1500热压缩模拟试验机研究了细晶铝锭熔炼的6063铝合金的高温变形行为

得出以下结论:选取560℃+6h固溶+250℃×3h时效的均匀化制度

流变应力较小

变形后时效硬度较高;560℃×6h固溶+250℃×3h时效处理的试样低温慢速变形可降低流变应力

但不利于Mg2Si相的溶解

进而影响变形后时效硬度;相同均匀化处理的试样

Mg2Si相含量高

则变形过程中流变应力大

细化方法的变化及含钛量的变化（含质量分数为0·01%

·05%的Ti）

对于热变形行为并未造成明显差异。

Abstract

Thermal deformation behavior of 6063 aluminum alloy produced with fine grain aluminum ingot at a high temperature has been observed with Gleeble 1 500 dynamic materials test machine.The results reveal that the deformed 6063 aluminum alloy has higher aging hardness with solid solution plus homogenized treatment at 250 ℃ for three hours due to reducing rheological stress.Low temperature and slow-speed deformation can decrease the rheological stress of the treated alloy sample

however

it can be harmful for the dissolution of Mg2Si phase

which obviously affects the aging hardness of the deformed alloy.The rheological stress of the deformed alloy can be increased with the increase of Mg2Si phase in the sample with the same homogenized treatment.The effects of refining ways and variation of Ti content in the deformed alloy on thermal deformation behavior can be ignored.