超声波搅拌法制备半固态Al-5Cu合金

李拥军; 程和法; 黄笑梅; 张章; 莫立娥

半固态加工 | 浏览量 : 0 下载量: 248 CSCD: 1

导出
分享
收藏
专辑

超声波搅拌法制备半固态Al-5Cu合金
Preparation of Semi-solid Al-5Cu Alloy by Ultrasonic Stirring
2007年第6期页码：448-450
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]李拥军,程和法,黄笑梅,张章,莫立娥.超声波搅拌法制备半固态Al-5Cu合金[J].特种铸造及有色合金,2007(06):448-450+407.

Li Yongjun, Cheng Hefa, Huang Xiaomei, et al. Preparation of Semi-solid Al-5Cu Alloy by Ultrasonic Stirring[J]. Special Casting & Nonferrous Alloys, 2007,(6):448-450.
[1]李拥军,程和法,黄笑梅,张章,莫立娥.超声波搅拌法制备半固态Al-5Cu合金[J].特种铸造及有色合金,2007(06):448-450+407. DOI：

Li Yongjun, Cheng Hefa, Huang Xiaomei, et al. Preparation of Semi-solid Al-5Cu Alloy by Ultrasonic Stirring[J]. Special Casting & Nonferrous Alloys, 2007,(6):448-450. DOI：

摘要

采用超声波搅拌法制备半固态Al-5Cu合金

研究了超声波导入时熔体的温度、搅拌时间和超声波输出功率3个重要参数对获得半固态Al-5Cu合金组织形貌的影响。结果表明

在熔体处于610～660℃之间导入超声波

随着熔体温度的升高

合金初生晶粒逐渐趋于细小的球状颗粒;当熔体为660℃时

随着导入超声波输出功率的增大、搅拌时间的延长

Al-5Cu合金初生相形貌由粗大的枝晶状逐渐转变为细小的球状晶粒。

Abstract

Semi-solid Al-5Cu alloy was prepared by ultrasonic stirring.The effects of important parameters

such as melt temperature

the ultrasonic treatment time and output power of ultrasonic stirrer

on the semi-solid structure of the alloy have been observed The results show that finer primary phase can be observed with increasing the melt temperature in the range of 610 to 660 ℃.In addition

the primary phase in the Al-5Cu alloy can be converted from coarse dendrite into fine spheroids with increasing the output power and time of ultrasonic stirrer at 660 ℃.