AZ91镁合金挤压组织和性能研究

潘国如; 王顺成

压力铸造 | 浏览量 : 0 下载量: 606 CSCD: 7

导出
分享
收藏
专辑

AZ91镁合金挤压组织和性能研究
Microstructure and Properties of Squeezing Casting AZ91 Magnesium Alloy
2007年第10期页码：778-780
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]潘国如,王顺成.AZ91镁合金挤压组织和性能研究[J].特种铸造及有色合金,2007(10):778-780+735.

Pan Guoru, Wang Shuncheng. Microstructure and Properties of Squeezing Casting AZ91 Magnesium Alloy[J]. Special Casting & Nonferrous Alloys, 2007,(10):778-780.
[1]潘国如,王顺成.AZ91镁合金挤压组织和性能研究[J].特种铸造及有色合金,2007(10):778-780+735. DOI：

Pan Guoru, Wang Shuncheng. Microstructure and Properties of Squeezing Casting AZ91 Magnesium Alloy[J]. Special Casting & Nonferrous Alloys, 2007,(10):778-780. DOI：

摘要

对AZ91镁合金铸锭进行（410±5）℃×10 h的固溶处理后

在330℃以挤压比为25∶1进行了挤压

研究了其组织和性能。结果表明

挤压AZ91镁合金具有较细的晶粒组织

第二相Mg17Al12被破碎

其分布变得弥散

个别呈流线分布;挤压AZ91镁合金比铸造AZ91镁合金的力学性能有较大提高

其屈服强度为210 MPa

抗拉强度为355 MPa

伸长率为18%。第二相Mg17Al12对镁合金的性能具有重要影响。

Abstract

The microstructure and properties of AZ91 magnesium alloy treated by solid solution at （410±5） ℃ for 10 hours have been investigated by squeezing casting with squeezing ratio of 25∶1 at 330 ℃. The results reveal that the fine grain in the squeezed AZ91 magnesium alloy can be observed

in which the Mg17Al12 phase is dispersively distributed due to its broken state

and some look on stream-flow distribution. Meanwhile

the yield strength

tensile strength and elongation of squeezed casting AZ91 magnesium alloy are 210 MPa

355 MPa and 18%

respectively

which are apparently superior to that of as-cast ones. The second phase Mg17Al12 has the important effects on the mechanical properties of the magnesium alloy.