破碎机锤头挤压铸造工艺及模具设计

吴夏玲; 邢书明; 姚淑卿; 鲍培玮; 牛建平

压力铸造 | 浏览量 : 0 下载量: 211 CSCD: 1

导出
分享
收藏
专辑

破碎机锤头挤压铸造工艺及模具设计
Squeezing Casting Mould Design of Hammer Head of Hammer Crusher and Its Process
2007年第11期页码：858-860
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]吴夏玲,邢书明,姚淑卿,鲍培玮,牛建平.破碎机锤头挤压铸造工艺及模具设计[J].特种铸造及有色合金,2007(11):858-860+817.

Wu Xialing1, Xing Shuming1, Yao Shuqing1, et al. Squeezing Casting Mould Design of Hammer Head of Hammer Crusher and Its Process[J]. Special Casting & Nonferrous Alloys, 2007,(11):858-860.
[1]吴夏玲,邢书明,姚淑卿,鲍培玮,牛建平.破碎机锤头挤压铸造工艺及模具设计[J].特种铸造及有色合金,2007(11):858-860+817. DOI：

Wu Xialing1, Xing Shuming1, Yao Shuqing1, et al. Squeezing Casting Mould Design of Hammer Head of Hammer Crusher and Its Process[J]. Special Casting & Nonferrous Alloys, 2007,(11):858-860. DOI：

摘要

根据破碎机锤头的结构和使用要求

结合高锰钢材料的特点

进行了破碎机锤头挤压铸造模具设计。挤压铸造成形设备采用专用挤压铸造机

其上挤压缸最大挤压力为12500kN。模具总体方案为间接成形

水平分模

1模3件

利用蝶簧与柱簧实现浮动模成形

充分利用锁模缸的能力

采用下缸上行间接顶件。

Abstract

Squeezing casting mould for the hammer head of hammer crusher was designed according to the structure of the hammer head and operating requirement combining with the features of high Mn steel.The special squeezing casting machine with maximum extruded force of 12 500 kN was adopted.Indirectional forming was adopted with horizontal mould-opening in the mould design

and butterfly spring and cylindrical spring were used to realize floating forming to fully utilize the ability of locking cylinder.In addition

the squeezing castings were pulled out by up-moving of bottom cylinder.