低压铸造铝合金轮毂充型和凝固过程模拟分析

苏大为; 赵玉涛

计算机应用技术 | 浏览量 : 0 下载量: 589 CSCD: 9

导出
分享
收藏
专辑

低压铸造铝合金轮毂充型和凝固过程模拟分析
Simulation of Filling and Solidification of Aluminum Alloy Wheel in Low Pressure Die Casting
2007年第9期页码：682-684
纸质出版日期： 2007 ，
DOI：

扫描看全文

[1]苏大为,赵玉涛.低压铸造铝合金轮毂充型和凝固过程模拟分析[J].特种铸造及有色合金,2007(09):682-684+653.

Su Dawei, Zhao Yutao. Simulation of Filling and Solidification of Aluminum Alloy Wheel in Low Pressure Die Casting[J]. Special Casting & Nonferrous Alloys, 2007,(9):682-684.
[1]苏大为,赵玉涛.低压铸造铝合金轮毂充型和凝固过程模拟分析[J].特种铸造及有色合金,2007(09):682-684+653. DOI：

Su Dawei, Zhao Yutao. Simulation of Filling and Solidification of Aluminum Alloy Wheel in Low Pressure Die Casting[J]. Special Casting & Nonferrous Alloys, 2007,(9):682-684. DOI：

摘要

利用ProCAST软件对某铝合金轮毂新产品的多种工艺方案进行模拟分析。模拟结果显示

铝合金

轮辋与轮辐的肋部交接位置易出现"孤立熔池"现象

为此提出降低边模温度

同时设计了轮辐与轮辋交接处的冷却系统及相应的工艺参数。通过对多种工艺方案模拟结果的对比分析

证明改进后的工艺方案几乎不出现"孤立熔池"现象

且实现了顺序凝固的要求。将改进后的工艺方案投入试生产

产品抽检结果与模拟结果基本符合。

Abstract

The filling and solidification of an aluminum alloy wheel in low pressure die casting were simulated by the ProCAST software. The simulated results reveal that the liquid-entrapped area often occurs in the intersection of the wheel rib and collar rim. Based on above-mentioned results

the simulation was conducted again by adjusting cooling system and its parameters at the intersection of the wheel rib and collar rim and decreasing temperature of side mould. The simulated results show that the absence of liquid-entrapped in modified filing process can be observed due to the realization of sequential-solidification. The trial production verifies that the product is well in agreement with the simulated results.