高能超声法制备SiC<sub>p</sub>/AZ91D纳米复合材料

贾秀颖; 高飞鹏; 张琼元; 刘世英; 李文珍

复合材料 | 浏览量 : 0 下载量: 251 CSCD: 8

导出
分享
收藏
专辑

高能超声法制备SiC_p/AZ91D纳米复合材料
Fabrication of Nano-SiC_p/AZ91D Composites by High-intensity Ultrasonic Method
2008年28卷第12期页码：962-964
纸质出版日期： 2008 ，
DOI：

扫描看全文

[1]贾秀颖,高飞鹏,张琼元,刘世英,李文珍.高能超声法制备SiC_p/AZ91D纳米复合材料[J].特种铸造及有色合金,2008,28(12):962-964+901.

Jia Xiuying, Gao Feipeng, Zhang Qiongyuan, et al. Fabrication of Nano-SiC_p/AZ91D Composites by High-intensity Ultrasonic Method[J]. Special Casting & Nonferrous Alloys, 2008,28(12):962-964.
[1]贾秀颖,高飞鹏,张琼元,刘世英,李文珍.高能超声法制备SiC_p/AZ91D纳米复合材料[J].特种铸造及有色合金,2008,28(12):962-964+901. DOI：

Jia Xiuying, Gao Feipeng, Zhang Qiongyuan, et al. Fabrication of Nano-SiC_p/AZ91D Composites by High-intensity Ultrasonic Method[J]. Special Casting & Nonferrous Alloys, 2008,28(12):962-964. DOI：

摘要

采用高能超声法制备纳米SiC颗粒增强AZ91D镁基纳米复合材料。高能超声能够使纳米级陶瓷颗粒在镁合金熔体中有效分散

所制备的复合材料抗拉强度和屈服强度等力学性能比基体有所提高。其中所用SiC颗粒粒径在40nm左右

在0.5%的添加量下复合材料可以获得较好的性能

铸态条件下抗拉强度超过200MPa。

Abstract

Nano-SiCp/AZ91D composites were prepared successfully by high intensity ultrasonic method.Tensile strength and yield strength of the prepared composites are superior to those of the matrix alloy as a result of high intensity ultrasonic obviously dispersing nano-ceramic particles in magnesium alloy melts.Tensile strength of the composites makes 200 MPa with 0.5% SiC addition with approximately 40 nm in size

exhibiting a better properties.

关键词

高能超声法镁基纳米复合材料纳米SiC颗料

Keywords

High Intensity Ultrasonic MethodMagnesium Matrix Nano-compositesNano-sized SiC Particles

references

文章被引用时，请邮件提醒。

提交

SiC_p/AZ61镁基纳米复合材料高能超声制备及阻尼性能研究

高能超声法制备SiCp/AZ91D纳米复合材料

Fabrication of Nano-SiCp/AZ91D Composites by High-intensity Ultrasonic Method

DOI：

摘要

Abstract

关键词

Keywords

references

高能超声法制备SiC_p/AZ91D纳米复合材料

Fabrication of Nano-SiC_p/AZ91D Composites by High-intensity Ultrasonic Method