旋转浇注法制备AZ91D半固态浆料

王小康; 王明; 杨湘杰; 郭洪民; 叶寒; 谢水生

半固态加工 | 浏览量 : 0 下载量: 158 CSCD: 7

导出
分享
收藏
专辑

旋转浇注法制备AZ91D半固态浆料
Preparation of Semi-solid AZ91D Alloy Slurry by Rotary Pouring Method
2008年第11期页码：846-848
纸质出版日期： 2008 ，
DOI：

扫描看全文

[1]王小康,王明,杨湘杰,郭洪民,叶寒,谢水生.旋转浇注法制备AZ91D半固态浆料[J].特种铸造及有色合金,2008(11):846-848+816-817.

Wang Xiaokang1, Wang Ming2, Yang Xiangjie2, et al. Preparation of Semi-solid AZ91D Alloy Slurry by Rotary Pouring Method[J]. Special Casting & Nonferrous Alloys, 2008,(11):846-848.
[1]王小康,王明,杨湘杰,郭洪民,叶寒,谢水生.旋转浇注法制备AZ91D半固态浆料[J].特种铸造及有色合金,2008(11):846-848+816-817. DOI：

Wang Xiaokang1, Wang Ming2, Yang Xiangjie2, et al. Preparation of Semi-solid AZ91D Alloy Slurry by Rotary Pouring Method[J]. Special Casting & Nonferrous Alloys, 2008,(11):846-848. DOI：

摘要

采用旋转浇注法制备AZ91D合金半固态浆料

获得了符合金属半固态加工要求的细小、近球状的非枝晶组织。研究表明

适当降低浇注温度、提高旋转管转动速度或采用合适的倾角

半固态组织的初生相颗粒会变得细小、均匀和圆整。在本试验条件下得到的优化工艺参数:浇注温度为630℃

旋转管转速为75r/min

旋转管倾角为25°。

Abstract

The semi-solid slurry with fine near-spheroidal structure of AZ91D alloy was prepared bya rotary pouring method.The results reveal that the primary phase particles with distributed fine spheroidal in semi-solid structure can be presented with decreasing the pouring temperature and increasing rotating velocity of the duct as well as choosing proper declined angular.The desirable semi-solid microstructure can be obtained with pouring at 630 ℃ and rotating at 75 r/min as well as declined angle of 25°.