铬矿砂应用于精密铸造抗粘砂工艺研究

陈顺国; 包彦堃

精密铸造 | 浏览量 : 0 下载量: 176 CSCD: 0

导出
分享
收藏
专辑

铬矿砂应用于精密铸造抗粘砂工艺研究
Application of Cr₂O₃·FeO in Investment Casting Heavy Parts
2009年29卷第3期页码：245-246
纸质出版日期： 2009 ，
DOI：

扫描看全文

[1]陈顺国,包彦堃.铬矿砂应用于精密铸造抗粘砂工艺研究[J].特种铸造及有色合金,2009,29(03):245-246+193.

Chen Shunguo1, Bao Yankun2. Application of Cr₂O₃·FeO in Investment Casting Heavy Parts[J]. Special Casting & Nonferrous Alloys, 2009,29(3):245-246.
[1]陈顺国,包彦堃.铬矿砂应用于精密铸造抗粘砂工艺研究[J].特种铸造及有色合金,2009,29(03):245-246+193. DOI：

Chen Shunguo1, Bao Yankun2. Application of Cr₂O₃·FeO in Investment Casting Heavy Parts[J]. Special Casting & Nonferrous Alloys, 2009,29(3):245-246. DOI：

摘要

精密铸造滑轮时

采用白刚玉砂（或粉）作为面层涂料时

表面经常产生粘砂缺陷

有时由于粘砂层难以清理而使铸件报废。采用铬铁矿砂（Cr2O3·FeO）

代替白刚玉砂作为表面层耐火材料

消除了表面粘砂

同时由于对铸件的厚大部分补缩效果增强

降低了缩孔、缩松缺陷

提高了成品率

分析了铬铁矿砂的作用机理。

Abstract

Burning-on defects often occurs in surface of investment casting pulley for port machinery when Al2O3 sand（powder）was used as surface layer coating of shell mold

which can result in the discard of the pulley due to not be able to clean.The surface burning-on defects in the investment casting pulley can be eliminated by using Cr2O3·FeO instead of Al2O3 sand（powder）as surface coating of mold shell

meanwhile

Cr2O3·FeO can decrease shrinkage porosity（hole）due to improving feeding effects on thick-large location in the investment casting pulley

increasing qualified product rate.Working mechanism of the Cr2O3·FeO sand was approached.