控制浇注温度制备的半固态ZL101合金的非枝晶组织

半固态加工 | 浏览量 : 0 下载量: 147 CSCD: 3

控制浇注温度制备的半固态ZL101合金的非枝晶组织
Fabrication and Mechanism of Non-dendrite Structure in Semi-solid ZL101 Alloy by Controlled Pouring Temperature
2009年29卷第3期页码：227-229
纸质出版日期： 2009 ，
DOI：

扫描看全文

[1]胥锴,刘徽平,王小平,袁帮谊,张书权.控制浇注温度制备的半固态ZL101合金的非枝晶组织[J].特种铸造及有色合金,2009,29(03):227-229+191.

Xu Kai1, Liu Huiping2, Wang Xiaoping1, et al. Fabrication and Mechanism of Non-dendrite Structure in Semi-solid ZL101 Alloy by Controlled Pouring Temperature[J]. Special Casting & Nonferrous Alloys, 2009,29(3):227-229.
[1]胥锴,刘徽平,王小平,袁帮谊,张书权.控制浇注温度制备的半固态ZL101合金的非枝晶组织[J].特种铸造及有色合金,2009,29(03):227-229+191. DOI：

Xu Kai1, Liu Huiping2, Wang Xiaoping1, et al. Fabrication and Mechanism of Non-dendrite Structure in Semi-solid ZL101 Alloy by Controlled Pouring Temperature[J]. Special Casting & Nonferrous Alloys, 2009,29(3):227-229. DOI：

采用控制浇注温度制备半固态ZL101合金

研究了不同的浇注温度对铸造显微组织的影响。结果表明

在680℃浇注时

形成粗大的枝晶组织;在625℃浇注时

获得的显微组织有部分枝晶存在;在615℃浇注时

可获得均匀、近球形的理想的半固态非枝晶组织;而在605℃浇注时

会形成较大晶粒的非枝晶组织。另外

探讨了非枝晶组织的形成机理。

Effects of pouring temperature on non-dendrite structure in as-cast microstructure of semi-solid ZL101 alloy were observed

which was prepared by controlling pouring method.The results reveal that coarse dendritic structure is observed with pouring at 680℃

and partly dendritic structure exists in the microstructure of the alloy with pouring at 625℃

and uniformly spheroidized non-dendrite structure can be obtained in the microstructure of the semi-solid ZL101 alloy with pouring at 615℃

while non-dendrite structure with large grain size can be created in the microstructure at 605℃.In addition

formation mechanism of non-dendrite structure in the microstructure of the semi-solid ZL101 alloy was approached.

浇注温度半固态成形ZL101合金非枝晶组织

Pouring TemperatureSemi-solidZL101 AlloyNon-dendritic Microstructure

文章被引用时，请邮件提醒。

提交