高性能Cu-Cr-Zr合金接触导线材料的制备与性能

刘琳静; 陈敬超; 冯晶; 洪振军; 杜晔平; 周晓龙

重有色合金 | 浏览量 : 0 下载量: 212 CSCD: 4

导出
分享
收藏
专辑

高性能Cu-Cr-Zr合金接触导线材料的制备与性能
Preparation and Properties of High Performance Cu-Cr-Zr Contact Lead Alloy
2009年29卷第9期页码：875-877
纸质出版日期： 2009 ，
DOI：

扫描看全文

[1]刘琳静,陈敬超,冯晶,洪振军,杜晔平,周晓龙.高性能Cu-Cr-Zr合金接触导线材料的制备与性能[J].特种铸造及有色合金,2009,29(09):875-877+784.

Liu Linjing, Chen Jingchao, Feng Jing, et al. Preparation and Properties of High Performance Cu-Cr-Zr Contact Lead Alloy[J]. Special Casting & Nonferrous Alloys, 2009,29(9):875-877.
[1]刘琳静,陈敬超,冯晶,洪振军,杜晔平,周晓龙.高性能Cu-Cr-Zr合金接触导线材料的制备与性能[J].特种铸造及有色合金,2009,29(09):875-877+784. DOI：

Liu Linjing, Chen Jingchao, Feng Jing, et al. Preparation and Properties of High Performance Cu-Cr-Zr Contact Lead Alloy[J]. Special Casting & Nonferrous Alloys, 2009,29(9):875-877. DOI：

摘要

采用原位合成法制备Cu-Cr-Zr合金

并对时效试样进行显微硬度、电导率及耐磨性能测试

研究结果表明

80%冷变形处理后最大电导率比初始电导率提高约一倍

变形量越大

合金的电导率越高

冷加工态的试样在500℃以下时效处理时

对导电率的影响十分明显

而对硬度的影响较小。合金材料的磨损试验表明

不带电磨损的机制主要为粘着磨损

带电情况下磨损机制主要为磨粒磨损。

Abstract

Micro-hardness

electric conductivity and wear resistance of aged Cu-Cr-Zr alloy prepared by in-situ synthesis were examined. The results reveal that compared with that of initial samples

electric conductivity of 80% cold deformed alloy is increased approximately 100%

furthermore

with increasing in deformation rate

the electric conductivity of the alloy is increased. After aged at 500℃ for the cold deformed alloy

electric conductivity is obviously affected

however

change of hardness is absent. Tribological behavior is characterized by adhesive abrasion under current free while it is abrasive abrasion under current conditions.