AZ31镁合金铸轧和常规轧制板拉伸变形的组织演变

赵虎; 何良菊; 李培杰

实用研究 | 浏览量 : 0 下载量: 282 CSCD: 2

导出
分享
收藏
专辑

AZ31镁合金铸轧和常规轧制板拉伸变形的组织演变
Microstructural Evolution of Cast-rolling and Normal Rolling AZ31 Magnesium Alloy Sheet
2009年29卷第3期页码：217-219
纸质出版日期： 2009 ，
DOI：

扫描看全文

[1]赵虎,何良菊,李培杰.AZ31镁合金铸轧和常规轧制板拉伸变形的组织演变[J].特种铸造及有色合金,2009,29(03):217-219+190-191.

Zhao Hu, He Liangju, Li Peijie. Microstructural Evolution of Cast-rolling and Normal Rolling AZ31 Magnesium Alloy Sheet[J]. Special Casting & Nonferrous Alloys, 2009,29(3):217-219.
[1]赵虎,何良菊,李培杰.AZ31镁合金铸轧和常规轧制板拉伸变形的组织演变[J].特种铸造及有色合金,2009,29(03):217-219+190-191. DOI：

Zhao Hu, He Liangju, Li Peijie. Microstructural Evolution of Cast-rolling and Normal Rolling AZ31 Magnesium Alloy Sheet[J]. Special Casting & Nonferrous Alloys, 2009,29(3):217-219. DOI：

摘要

采用Gleebe-1500D热模拟试验机对AZ31镁合金铸轧板和常规轧制板进行了等温拉伸试验

变形温度为150～400℃

应变速率为3×10-4～3×10-1s-1。研究了AZ31镁合金铸轧板和常规轧制板在不同变形条件下的组织演变。结果表明

两种板低温变形后的组织主要包括被拉长和破碎的晶粒以及孪晶。随着变形温度的升高

AZ31镁合金开始发生动态再结晶。铸轧板高温低应变速率变形条件下晶界滑移引起的空洞尺寸、体积分数和密度均大于常规轧制板。再结晶晶粒尺寸和参数Z呈幂律关系。

Abstract

Isothermal tensile of cast-rolling and normal rolling AZ31 magnesium alloy sheet was tested on the Gleeble 1500D hot simulator with strain rate of 0.3～0.0003 s-1 at 150～400 ℃ to observe microstructural evolution.The results indicate that microstructure of AZ31 magnesium alloy mainly consists of elongated and broken grains and twins at the low temperature deformation.With increasing in temperature

recrystallization occurs and grain size is coarsened in the microstructure of cast-rolling and normal rolling AZ31 magnesium alloy sheets.Cavity size

volume fraction and density of cast-rolling sheet caused by grain boundary sliding under the deformation condition of high temperature and low strain are higher than those of normal rolling ones

while dynamic recrystallization grain sizes are less than that of normal rolling ones.Dynamic recrystallization grain size has a power law relation with Z parameters.