SiC<sub>P</sub>/AZ61复合材料触变铸造的有限元模拟

张发云; 闫洪

计算机应用技术 | 浏览量 : 0 下载量: 119 CSCD: 0

导出
分享
收藏
专辑

SiC_P/AZ61复合材料触变铸造的有限元模拟
Finite Element Simulation of Thixo-forging SiC_P/AZ61 Composites Intermediate Shaft Screw Plug for the Automobile
2009年29卷第10期页码：911-914
纸质出版日期： 2009 ，
DOI：

扫描看全文

[1]张发云,闫洪.SiC_P/AZ61复合材料触变铸造的有限元模拟[J].特种铸造及有色合金,2009,29(10):911-914+877.

Zhang Fayun1, Yan Hong2. Finite Element Simulation of Thixo-forging SiC_P/AZ61 Composites Intermediate Shaft Screw Plug for the Automobile[J]. Special Casting & Nonferrous Alloys, 2009,29(10):911-914.
[1]张发云,闫洪.SiC_P/AZ61复合材料触变铸造的有限元模拟[J].特种铸造及有色合金,2009,29(10):911-914+877. DOI：

Zhang Fayun1, Yan Hong2. Finite Element Simulation of Thixo-forging SiC_P/AZ61 Composites Intermediate Shaft Screw Plug for the Automobile[J]. Special Casting & Nonferrous Alloys, 2009,29(10):911-914. DOI：

摘要

采用DEFORM3D软件对SiCP/AZ61复合材料汽车中间轴螺塞触变铸造过程进行了数值模拟

分析了汽车中间轴螺塞材料的流动规律

着重研究了冲头速度和SiC颗粒体积分数对其触变铸造成形过程的影响

并进行了相应的触变铸造工艺试验研究。结果表明

在相同的成形工艺条件下

SiCP/AZ61复合材料汽车中间轴螺塞的等效应力随着SiC颗粒体积分数的增加而增大;而冲头速度的提高

使得其等效应力明显增大

等效应变分布更均匀。

Abstract

Thixo-forging SiCP/AZ61 composites intermediate shaft screw plug was simulated by the Deform-3D software to understand the flow behavior of the composites melt

especially effects of punch velocity and SiC particle volumetric fraction on thixo-forging process. The results show that

with the same forming processes

the equivalent stress of the SiCP/AZ61 composites intermediate shaft screw plug for the automobile is increased with increasing in SiC particle volumetric fraction

and with the increase of punch velocity

the equivalent stress is greatly increased with more uniform distribution. The thixo-forging experiment was conducted also.