响应面分析法优化锆英粉陶瓷型真空干燥工艺

张业明; 曾明; 胡丽; 刘新刚; 张聪正

精密铸造 | 浏览量 : 0 下载量: 82 CSCD: 0

导出
分享
收藏
专辑

响应面分析法优化锆英粉陶瓷型真空干燥工艺
Optimization of Vacuum Drying Parameters for Zr-based Ceramic Mold with Response Surface Methodology（RSM）
2009年29卷第11期页码：1036-1038
纸质出版日期： 2009 ，
DOI：

扫描看全文

[1]张业明,曾明,胡丽,刘新刚,张聪正.响应面分析法优化锆英粉陶瓷型真空干燥工艺[J].特种铸造及有色合金,2009,29(11):1036-1038+977.

Zhang Yeming, Zeng Ming, Hu Li, et al. Optimization of Vacuum Drying Parameters for Zr-based Ceramic Mold with Response Surface Methodology（RSM）[J]. Special Casting & Nonferrous Alloys, 2009,29(11):1036-1038.
[1]张业明,曾明,胡丽,刘新刚,张聪正.响应面分析法优化锆英粉陶瓷型真空干燥工艺[J].特种铸造及有色合金,2009,29(11):1036-1038+977. DOI：

Zhang Yeming, Zeng Ming, Hu Li, et al. Optimization of Vacuum Drying Parameters for Zr-based Ceramic Mold with Response Surface Methodology（RSM）[J]. Special Casting & Nonferrous Alloys, 2009,29(11):1036-1038. DOI：

摘要

采用胶态浇注成型技术和真空干燥方法制备表面无裂纹的锆英粉陶瓷铸型。通过统计试验设计的方法对陶瓷型真空干燥进行优化。采用单因素试验

对影响真空干燥工艺的真空度、真空干燥温度、真空干燥时间3因素进行考察。利用Box-Behnken设计对此3个主要因素的最佳水平进行进一步研究。结果表明

在真空度、真空干燥温度和真空干燥时间分别为0.06MPa、81℃和5h时

陶瓷型铸型的干燥收缩率和强度分别为0.686%和6.39MPa。

Abstract

Zr-based ceramic mold with surface crack free was prepared by the colloidal pouring forming technology and vacuum drying method.Vacuum drying parameters for ceramic mold were optimized by statistical experiment design.Vacuum

vacuum drying temperature and vacuum drying time influencing the processing were investigated by single factor experiment.The optimized processing parameters were presented by the Box-Behnken design.The drying shrinkage rate and compressive strength of the ceramic mold reach 0.686%

6.39MPa with 0.06MPa at 81℃ for 5 hours.