Ju Xinqing, Wang Shuqi, Yang Zirui, et al. Effects of Mg on Reaction Process and Morphology of Reaction Product in Al-Ti System[J]. Special Casting & Nonferrous Alloys, 2009,29(6):542-545.
Ju Xinqing, Wang Shuqi, Yang Zirui, et al. Effects of Mg on Reaction Process and Morphology of Reaction Product in Al-Ti System[J]. Special Casting & Nonferrous Alloys, 2009,29(6):542-545.DOI:
Mg对Al-Ti体系反应及产物形貌的影响
摘要
研究了Mg对Al-Ti体系反应、产物形貌和相对致密度的影响
并制备出Mg基复合材料。结果表明
Al-Ti体系的反应合成产物主要是Al3Ti。Mg的作用是降低了Al-Ti体系反应合成的起始温度
延迟了Al-Ti体系反应合成的起始时间;随着Mg含量的增加
Al-Ti体系产物的相对致密度不断提高
Mg的含量为75%时反应产物的相对致密度达到97.0%。Mg的存在使生成的Al3Ti颗粒细化
且颗粒圆整
分布均匀
采用Al-Ti体系原位反应生成的颗粒状Al3Ti增强Mg基复合材料
其颗粒尺寸为1~3μm
相对均匀分布在Mg基体上。
Abstract
Effects of Mg on reaction process
morphology and relative density of reaction products in Mg-Al-Ti system were investigated
and the Mg matrix composites were successfully prepared.The results reveal that the Al3Ti phase is dominant in reaction products in Mg-Al-Ti system.Mg element plays a role in decreasing initial temperature and in extending initial time of synthesized reaction of Mg-Al-Ti system.With increasing in Mg content
relative density of reaction products is obviously improved
where the relative density reaches 97.0% with 75% Mg content.In addition
created Al3Ti particles exhibiting round morphology and uniform distribution are refined with Mg addition.As a result
Al3Ti particle reinforced Mg matrix composites with 1
3
μm of Al3Ti which is relatively uniformly distributed in Mg matrix can be successfully fabricated by in-situ reaction synthesis in Mg-Al-Ti system.
关键词
Al-Ti体系Mg基复合材料反应合成显微组织致密度
Keywords
Al-TiMg Matrix CompositesReactive SynthesisMicrostructureRelative Density