5083合金挤压铸造工艺的研究

王家宣; 诸葛跃; 姜丽红; 罗贻正

压力铸造 | 浏览量 : 0 下载量: 225 CSCD: 5

导出
分享
收藏
专辑

5083合金挤压铸造工艺的研究
Production of 5083 Alloy Parts by Squeezing Casting
2010年30卷第1期页码：57-59
纸质出版日期： 2010 ，
DOI：

扫描看全文

[1]王家宣,诸葛跃,姜丽红,罗贻正.5083合金挤压铸造工艺的研究[J].特种铸造及有色合金,2010,30(01):57-59+125.

Wang Jiaxuan, Zhuge Yue, Jiang Lihong, et al. Production of 5083 Alloy Parts by Squeezing Casting[J]. Special Casting & Nonferrous Alloys, 2010,30(1):57-59.
[1]王家宣,诸葛跃,姜丽红,罗贻正.5083合金挤压铸造工艺的研究[J].特种铸造及有色合金,2010,30(01):57-59+125. DOI：

Wang Jiaxuan, Zhuge Yue, Jiang Lihong, et al. Production of 5083 Alloy Parts by Squeezing Casting[J]. Special Casting & Nonferrous Alloys, 2010,30(1):57-59. DOI：

摘要

以5083合金为原材料进行挤压铸造工艺试验。采用正交试验和极差分析法确定了最佳工艺条件——比压为125MPa

浇注温度为670℃

保压时间为15s。对该工艺条件下试样的微观组织和力学性能进行了分析。结果表明

与普通铸造成形制件相比

挤压铸造成形制件微观组织更加细小、均匀

综合力学性能显著提高

达到或者接近了原热模锻工艺水平。

Abstract

A 5083 alloy trial-part was produced by squeezing casting.The optimized processing parameters

such as specific pressure of 125MPa

pouring at 670℃ for 15 s

were presented based on orthogonal testing and range analysis.Microstructure and mechanical properties of the squeezed parts in condition of the optimized parameters were analyzed.Compared with conventional casting parts

the squeezed casting parts exhibit finer and more uniform microstructure as well as the higher comprehensive mechanical properties

reaching up to or approaching the mechanical properties of hot forging ones.