半固态准共晶铝硅合金的设计与坯料制备

周岐; 张广安; 武晓峰

半固态加工 | 浏览量 : 0 下载量: 174 CSCD: 0

导出
分享
收藏
专辑

半固态准共晶铝硅合金的设计与坯料制备
Design of Semi-solid Quasi-eutectic Al-Si Alloy and Billets Preparation
2010年30卷第1期页码：46-48
纸质出版日期： 2010 ，
DOI：

扫描看全文

[1]周岐,张广安,武晓峰.半固态准共晶铝硅合金的设计与坯料制备[J].特种铸造及有色合金,2010,30(01):46-48+124.

Zhou Qi, Zhang Guang’an, Wu Xiaofeng. Design of Semi-solid Quasi-eutectic Al-Si Alloy and Billets Preparation[J]. Special Casting & Nonferrous Alloys, 2010,30(1):46-48.
[1]周岐,张广安,武晓峰.半固态准共晶铝硅合金的设计与坯料制备[J].特种铸造及有色合金,2010,30(01):46-48+124. DOI：

Zhou Qi, Zhang Guang’an, Wu Xiaofeng. Design of Semi-solid Quasi-eutectic Al-Si Alloy and Billets Preparation[J]. Special Casting & Nonferrous Alloys, 2010,30(1):46-48. DOI：

摘要

根据汽车空调配件使用性能的要求和半固态加工的特点

设计了适于半固态加工的汽车空调配件用高强耐热Al-10.5Si-2.5Cu-1.0Mg-Mn合金。利用低过热度浇注技术制备出组织为非枝晶状的Al-10.5Si-2.5Cu-1.0Mg-Mn合金半固态坯料

其最佳浇注温度为583℃;在接近液相线的低温保持一定时间

熔体中形成大量的细小自由（游离）晶体

并保持高的存活率

是Al-10.5Si-2.5Cu-1.0Mg-Mn合金半固态非枝晶组织形成的主要原因。

Abstract

Based on performance requirements of automobile air condition accessories and characteristics of semi-solid process

quasi-eutectic Al-Si alloy Al-10.5Si-2.5Cu-1.0Mg-Mn was developed.The semi-solid billets with non-dendrite structure was prepared at 583℃by low-super-heating pouring technology.Amounts of free fine nuclei with high survival rate are created in the melt with holding for some time at low temperature nearby liquidus

which is responsible for the formation of non-dendrite on the aluminum alloy semi-solid billets.