Effects of Aging Treatment on Microstructure and Properties of Cu-0.92Cr Alloy after Thermal Deformation[J]. Special Casting & Nonferrous Alloys, 2010,30(11):1074-1076.
Effects of Aging Treatment on Microstructure and Properties of Cu-0.92Cr Alloy after Thermal Deformation[J]. Special Casting & Nonferrous Alloys, 2010,30(11):1074-1076.DOI:
热变形后时效工艺对Cu-0.92Cr合金组织和性能的影响
摘要
采用热变形+固溶+热变形+冷变形+时效工艺制备了Cu-0.92Cr合金试样
测试了试样的硬度和电导率
并进行了微观组织观察
研究了热变形后时效工艺对Cu-0.92Cr合金组织和性能的影响。结果表明
在试验参数范围内
随着时效温度的升高和时间的延长
合金的硬度逐渐下降
电导率升高。在420℃×6h时效后
合金硬度(HB)为130.3
电导率可达52.49MS/m。组织观察表明
经时效后析出相为具有面心立方结构、晶格参数为0.424nm的化合物
颗粒大小约为4~15nm
颗粒间距为10~30nm。
Abstract
The Cu-0.92Cr alloy was prepared by thermal deformation-solid solution-thermal deformation-cold deformation-aging treatment.The hardness and electric conductivity of the Cu-0.92Cr alloy have been examined
and microstructure of the alloy with aging at 420 ℃ for 6h was observed to understand effects of aging process on microstructure and properties of Cu-0.92Cr alloy after thermal deformation.The results reveal that with increasing in aging temperature and time
hardness of the alloy is gradually decreased and electric conductivity is increased.The hardness and electric conductivity of the alloy with aging at 420℃ for 6h reach up to 130.3HB and 52.49MS/m
respectively.The Cu-0.92Cr alloy is characterized by uniform distribution of precipitates in Cu matrix.The precipitates are found to have the f.c.c structure with the lattice parameter of 0.424nm
and particle size is approximately 4~15nm with grain spacing approximately 10~30nm.