Zr44Ti11Ni10Cu10Be25块体非晶合金与金属铝箔的扩散连接

吴超辉; 陆琪; 沈博智; 袁子洲

特种合金 | 浏览量 : 0 下载量: 219 CSCD: 1

导出
分享
收藏
专辑

Zr₄₄Ti₁₁Ni₁₀Cu₁₀Be₂₅块体非晶合金与金属铝箔的扩散连接
Diffusion Bonding of Zr₄₄Ti₁₁Ni₁₀Cu₁₀Be₂₅ Bulk Amorphous Alloy with Aluminum Foil
2011年31卷第1期页码：79-82
纸质出版日期： 2011 ，
DOI：

扫描看全文

[1]吴超辉,陆琪,沈博智,袁子洲.Zr_(44)Ti_(11)Ni_(10)Cu_(10)Be_(25)块体非晶合金与金属铝箔的扩散连接[J].特种铸造及有色合金,2011,31(01):79-82+107.

Wu Chaohui, Lu Qi, Shen Bozhi, et al. Diffusion Bonding of Zr₄₄Ti₁₁Ni₁₀Cu₁₀Be₂₅ Bulk Amorphous Alloy with Aluminum Foil[J]. Special Casting & Nonferrous Alloys, 2011,31(1):79-82.
[1]吴超辉,陆琪,沈博智,袁子洲.Zr_(44)Ti_(11)Ni_(10)Cu_(10)Be_(25)块体非晶合金与金属铝箔的扩散连接[J].特种铸造及有色合金,2011,31(01):79-82+107. DOI：

Wu Chaohui, Lu Qi, Shen Bozhi, et al. Diffusion Bonding of Zr₄₄Ti₁₁Ni₁₀Cu₁₀Be₂₅ Bulk Amorphous Alloy with Aluminum Foil[J]. Special Casting & Nonferrous Alloys, 2011,31(1):79-82. DOI：

摘要

采用铜模吹铸法制备出Zr44Ti11Ni10Cu10Be25块体非晶合金

并在真空扩散焊设备中与铝箔进行扩散焊接

研究了锆基非晶合金与Al箔进行超塑性扩散焊连接工艺及其连接界面的原子扩散情况。结果表明

元素的扩散情况与试样的变形量有关

但变形量又不完全影响元素的扩散

而是当变形量达到一定值时

温度越高

元素扩散程度越高。当温度达到713K、变形量达到26%时

元素的扩散程度最高。

Abstract

bulk amorphous alloy was prepared by blowing out with copper mold casting

and superplastic diffusion bonding of the Zr-based amorphous alloy with Al foil was conducted in vacuum diffusion-welding equipment to understand atom diffusion behavior in bonding interface.The results reveal that diffusion of element is related to the deformation of samples to some extent.When deformation rate reaches a critical value

with increasing in temperature

diffusion rate of element is increased.The maximum diffusion rate of element in the interface can be observed with 26% deformation rate at 713K.