氩弧熔覆原位自生NbC增强镍基复合涂层分析

王永东; 李柏茹; 王淑花; 刘兴; 朱艳

实用研究 | 浏览量 : 0 下载量: 164 CSCD: 4

导出
分享
收藏
专辑

氩弧熔覆原位自生NbC增强镍基复合涂层分析
Analysis of in-situ NbC Reinforced Ni-based Composite Coating by Argon Arc Cladding
2011年31卷第3期页码：206-208
纸质出版日期： 2011 ，
DOI：

扫描看全文

[1]王永东,李柏茹,王淑花,刘兴,朱艳.氩弧熔覆原位自生NbC增强镍基复合涂层分析[J].特种铸造及有色合金,2011,31(03):206-208+189-190.

Wang Yongdong, Li Bairu, Wang Shuhua, et al. Analysis of in-situ NbC Reinforced Ni-based Composite Coating by Argon Arc Cladding[J]. Special Casting & Nonferrous Alloys, 2011,31(3):206-208.
[1]王永东,李柏茹,王淑花,刘兴,朱艳.氩弧熔覆原位自生NbC增强镍基复合涂层分析[J].特种铸造及有色合金,2011,31(03):206-208+189-190. DOI：

Wang Yongdong, Li Bairu, Wang Shuhua, et al. Analysis of in-situ NbC Reinforced Ni-based Composite Coating by Argon Arc Cladding[J]. Special Casting & Nonferrous Alloys, 2011,31(3):206-208. DOI：

摘要

以碳粉、铌粉和Ni60A粉为原料

利用氩弧熔覆技术在Q345钢基材表面原位合成了NbC增强Ni基复合涂层

应用SEM

XRD对涂层的显微组织和物相进行了分析

并测试了涂层显微硬度和常温耐磨性。结果表明

复合涂层与基体界面无气孔、裂纹

呈冶金结合;涂层组织由γ-Ni

Cr23C6和NbC颗粒相组成。涂层的显微硬度HV0.2达到1000

较基体提高3倍左右;耐磨性较基体Q345钢提高近11倍。

Abstract

NbC reinforced Ni-based composite coating was fabricated on the surface of Q345 steel by means of argon arc cladding technique with powder of C

Nb and Ni60A. Microstructure and phase constituent of the coating were observed by SEM （scanning electron microscope） and XRD （X-ray diffraction）

meanwhile

micro-hardness and ambient wear resistance of the coating were measured. It is found that absence of gas hole and crack in interface of composite coating with the matrix can be observed

exhibiting desirable metallurgical bonding. Microstructure of the composite coating is composed of γ-Ni

Cr23C6 and NbC. Micro-hardness of the composite coating reaches up to 1000

increased by approximately three times compared with that of the matrix alloy

and wear resistance is increased by approximately 11 times compared with the matrix.