English Version
复合材料 | 浏览量 : 29 下载量: 301 CSCD: 3
  • 导出

  • 分享

  • 收藏

  • 专辑

    • 粉末冶金法制备纳米MgO颗粒增强铜基复合材料

    • Microstructure and Properties of Nano-MgO Particle Reinforced Copper Matrix Composites Prepared by Powder Metallurgy

    • 郑翠华

      12

      宋克兴

      12

      国秀花

      123

      李韶林

      12

      丁宗业

      12
    • 2011年31卷第10期 页码:955-958   

      纸质出版日期: 2011

    扫 描 看 全 文

  • 引用

  • [1]郑翠华,宋克兴,国秀花,李韶林,丁宗业.粉末冶金法制备纳米MgO颗粒增强铜基复合材料[J].特种铸造及有色合金,2011,31(10):955-958. DOI:
    Zheng Cuihua1, Song Kexing1, Guo Xiuhua1, et al. Microstructure and Properties of Nano-MgO Particle Reinforced Copper Matrix Composites Prepared by Powder Metallurgy[J]. Special Casting & Nonferrous Alloys, 2011,31(10):955-958. DOI:
  •  
  •  
    论文导航

    摘要

    采用粉末冶金法制备了不同体积分数的纳米MgO颗粒增强铜基复合材料,测定了MgO/Cu复合材料的密度、硬度和电导率,并进行了微观组织观察。结果表明,随着MgO颗粒含量的增加,MgO/Cu复合材料的密度和电导率降低,硬度先升高后降低,当MgO体积分数达到2.5%时,综合性能最好。微观组织观察表明,热挤压后,增强相颗粒弥散分布在铜基体上;随着增强相体积分数的增加,颗粒出现团聚并聚集在铜基体晶界处。

    Abstract

    The varied volumetric fraction nano-MgO particle reinforced copper matrix composites(MgO/Cu composites) were prepared by powder metallurgy technology. The hardness,density and electric conductivity of the MgO/Cu composites were examined,and its microstructure was observed. The results indicate that,with increasing in MgO particle content,density and electric conductivity of the composites are decreased,however,hardness is firstly increased and then decreased. The desirable comprehensive properties of the composites can be obtained with 2.5% MgO particle. Reinforcement is uniformly and dispersedly distributed into the copper matrix after hot extrusion. With increasing in volumetric fraction of reinforcement,nano-particles appear together and gather in grain boundary of copper matrix.

    关键词

    粉末冶金法; 纳米MgO颗粒; 电导率; 密度; 硬度

    Keywords

    Powder Metallurgy; MgO Nano-particle; Electric Conductivity; Density; Hardness

    文章被引用时,请邮件提醒。
    提交

    相关作者

    李韶林 河南科技大学材料科学与工程学院; 河南省有色金属材料科学与加工技术重点实验室
    宋克兴 河南科技大学材料科学与工程学院; 河南省有色金属材料科学与加工技术重点实验室
    国秀花 河南科技大学材料科学与工程学院; 河南省有色金属材料科学与加工技术重点实验室; 西安理工大学材料科学与工程学院
    刘柏雄 江西理工大
    张丽娜 江西理工大
    韩宝军   2. 上海交通大学  
    刘金明 江西理工大学
    孟祥锋 辽宁工程技术大学材料科学与工程学院

    相关机构

    河南科技大学材料科学与工程学院
    河南省有色金属材料科学与加工技术重点实验室
    西安理工大学材料科学与工程学院
    江西理工大
      2. 上海交通大学  
    0