锡磷青铜水平连铸结晶器一次冷却优化设计

郭丽丽; 姜业欣; 李学帅; 吕文波

连续铸造 | 浏览量 : 0 下载量: 182 CSCD: 2

导出
分享
收藏
专辑

锡磷青铜水平连铸结晶器一次冷却优化设计
Optimized Design of Primary Cooling in Mould for Bronze Horizontal Continuous Casting
2011年31卷第5期页码：441-443
纸质出版日期： 2011 ，
DOI：

扫描看全文

[1]郭丽丽,姜业欣,李学帅,吕文波.锡磷青铜水平连铸结晶器一次冷却优化设计[J].特种铸造及有色合金,2011,31(05):441-443+389.

Guo Lili, Jiang Yexin, Li Xueshuai, et al. Optimized Design of Primary Cooling in Mould for Bronze Horizontal Continuous Casting[J]. Special Casting & Nonferrous Alloys, 2011,31(5):441-443.
[1]郭丽丽,姜业欣,李学帅,吕文波.锡磷青铜水平连铸结晶器一次冷却优化设计[J].特种铸造及有色合金,2011,31(05):441-443+389. DOI：

Guo Lili, Jiang Yexin, Li Xueshuai, et al. Optimized Design of Primary Cooling in Mould for Bronze Horizontal Continuous Casting[J]. Special Casting & Nonferrous Alloys, 2011,31(5):441-443. DOI：

摘要

设计的新型结晶器是在结晶器的上表面增加了出水口的数量

使结晶器上下表面的出水口不对称

克服由于铜液的重力使铸坯在下表面先结晶的缺点

在减小铸坯下表面的冷却强度的同时

还提高了铸坯的结晶中心线

使铸坯的成分均匀

进而改变了铜液对下表面凝壳的压力

降低引锭阻力

使下表面的石墨板的寿命变长。由于上下表面的冷却强度趋于一致

故减少了铸坯中存在的缺陷

使带材的成品率明显提高。

Abstract

A new mould was designed by adding outlet numbers on upper surface

which made asymmetry outlet at upper and bottom surface.The mould not only decreased cooling intensity of bottom surface of the billet

but also improved the crystallized middle line to homogenize constituent in the billets as a result of overcoming gravidity of liquid copper to make bottom surface crystallization ahead.Furthermore

the design could increase service life of the graphite plate on bottom surface by decreasing pressure of liquid copper on solidified skull at bottom surface to decrease dummy drag force.Defects in the billets were decreased as a result of low temperature gradient between upper and bottom surface

improving the yield of strip.