铸造CAE在解决汽车铸件铸造缺陷中的应用

徐义武; 管文浩; 马洪亮

计算机应用技术 | 浏览量 : 0 下载量: 177 CSCD: 2

导出
分享
收藏
专辑

铸造CAE在解决汽车铸件铸造缺陷中的应用
Application of Casting CAE in Eliminating Defects in Casting Parts for Automobile
2011年31卷第8期页码：715-717
纸质出版日期： 2011 ，
DOI：

扫描看全文

[1]徐义武,管文浩,马洪亮.铸造CAE在解决汽车铸件铸造缺陷中的应用[J].特种铸造及有色合金,2011,31(08):715-717.

Xu Yiwu~1, Guan Wenhao~2, Ma Hongliang~2. Application of Casting CAE in Eliminating Defects in Casting Parts for Automobile[J]. Special Casting & Nonferrous Alloys, 2011,31(8):715-717.
[1]徐义武,管文浩,马洪亮.铸造CAE在解决汽车铸件铸造缺陷中的应用[J].特种铸造及有色合金,2011,31(08):715-717. DOI：

Xu Yiwu~1, Guan Wenhao~2, Ma Hongliang~2. Application of Casting CAE in Eliminating Defects in Casting Parts for Automobile[J]. Special Casting & Nonferrous Alloys, 2011,31(8):715-717. DOI：

摘要

某汽车雨刮器臂在疲劳测试过程中出现断裂

发现断裂位置存在缩孔和气孔缺陷。借助铸造CAE软件对产品现有模具设计进行了模拟分析

发现缺陷产生的原因并提出对策。通过多次对模具方案的修改并模拟

得到最佳方案

并在模具上实施。经雨刮器臂疲劳测试验证

未再发生断裂

从而提高了产品品质。

Abstract

There exist shrinkage hole and gas hole in crack location of a wiper arm head during fatigue testing.Mould design of the produced parts was analyzed by the help of CAE software.The origination of defects was presented

and countermeasures were provided.Optimized design was obtained through modifying mould and simulation to be implemented on the production.Absence of crack was observed through fatigue testing

improving the quality of product.