变形、时效对AZ80镁合金组织性能的影响

李伟东; 周海涛; 陈和兴; 郑开宏; 戚文军

轻有色合金 | 浏览量 : 0 下载量: 356 CSCD: 1

导出
分享
收藏
专辑

变形、时效对AZ80镁合金组织性能的影响
Effect of Deformation and Ageing Treatment on Microstructure and Properties of AZ80 Magnesium Alloy
2011年31卷第12期页码：1170-1174
纸质出版日期： 2011 ，
DOI：

扫描看全文

[1]李伟东,周海涛,陈和兴,郑开宏,戚文军.变形、时效对AZ80镁合金组织性能的影响[J].特种铸造及有色合金,2011,31(12):1170-1174.

Li Weidong1, Zhou Haitao1, Chen Hexing2, et al. Effect of Deformation and Ageing Treatment on Microstructure and Properties of AZ80 Magnesium Alloy[J]. Special Casting & Nonferrous Alloys, 2011,31(12):1170-1174.
[1]李伟东,周海涛,陈和兴,郑开宏,戚文军.变形、时效对AZ80镁合金组织性能的影响[J].特种铸造及有色合金,2011,31(12):1170-1174. DOI：

Li Weidong1, Zhou Haitao1, Chen Hexing2, et al. Effect of Deformation and Ageing Treatment on Microstructure and Properties of AZ80 Magnesium Alloy[J]. Special Casting & Nonferrous Alloys, 2011,31(12):1170-1174. DOI：

摘要

研究了变形、时效对AZ80镁合金组织性能的影响。铸态AZ80镁合金经470℃×8h固溶处理

然后在400℃条件下进行不同变形量的热轧变形

变形后的部分镁合金进行170℃×16h时效处理。结果表明

随着变形量的增加晶粒得到细化

当变形量达到80%时

晶粒尺寸由铸态的105μm细化到3μm

此时抗拉强度达到282.49MPa;合金的伸长率先增加后减小

变形量为50%时伸长率达到最大

为24.21%;屈服强度先降低后增加。

Abstract

The effect of deformation and ageing treatment on microstructure and properties of AZ80 magnesium alloy were investigated.Firstly

AZ80 magnesium alloy is treated with solid solution treatment at 470 ℃ for 8 h.And then

it is hot-rolled with varied deformation rate at 400℃.Finally

the hot rolled magnesium alloy is treated with ageing treatment at 170 ℃ for 16 h.The results show that the grain size can be refined with the increase of deformation rate.With deformation rate of 80%

the average grain size is refined from 105 μm to 3 μm

and tensile strength reaches 282.49 MPa.Meanwhile

the elongation exhibits first increased and then reduced

where it can reach 24.21% with deformation rate of 50%.In addition

the yield strength is first reduced and then increased.