Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software

Wu Yaorong; Cen Weiming; Deng Yubin; Liang Fu

doi:10.15980/j.tzzz.2019.06.009

Views : 0 下载量: 79 CSCD: 2

Export
Share
Collection
Album

Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software
Vol. 39, Issue 6, Pages: 618-621(2019)
Published： 2019 ，
DOI： 10.15980/j.tzzz.2019.06.009

扫描看全文

[1]吴耀荣,岑伟明,邓宇斌,梁富.基于FLOW-3D的减震塔真空压铸工艺设计与优化[J].特种铸造及有色合金,2019,39(06):618-621.

Wu Yaorong, Cen Weiming, Deng Yubin, et al. Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software. [J]. Special Casting & Nonferrous Alloys 39(6):618-621(2019)
[1]吴耀荣,岑伟明,邓宇斌,梁富.基于FLOW-3D的减震塔真空压铸工艺设计与优化[J].特种铸造及有色合金,2019,39(06):618-621. DOI： 10.15980/j.tzzz.2019.06.009.

Wu Yaorong, Cen Weiming, Deng Yubin, et al. Design and Optimization of Die Casting Process for Vacuum Die Casting Shocking Tower Based on Flow-3D Software. [J]. Special Casting & Nonferrous Alloys 39(6):618-621(2019) DOI： 10.15980/j.tzzz.2019.06.009.

摘要

基于Flow-3D软件

分析了工艺设计过程

利用模拟分析软件

经过多次模流的相互对比和分析

确定了减震塔铸件的浇注方案。根据该方案模拟抽真空的状态

经过模拟分析

预测其可能产生的缺陷及位置

并提出相应的改进措施。

Abstract

The optimized gating system was determined for the vacuum die casting shocking tower based on the Flow-3 Dsoftware with different editions to analyze comparatively the gating system design.Through simulation analysis

the potential defects in the shocking tower during filling and solidification process were visualized

and the optimized structure in the mould design was conducted.