Design Optimization of ZL205A Frame Casting in Solidification Process

Xiang Tao

doi:10.15980/j.tzzz.2018.05.009

Views : 0 下载量: 39 CSCD: 2

Export
Share
Collection
Album

Design Optimization of ZL205A Frame Casting in Solidification Process
Vol. 38, Issue 5, Pages: 497-500(2018)
Published： 2018 ，
DOI： 10.15980/j.tzzz.2018.05.009

扫描看全文

[1]向涛.ZL205A副构架铸件凝固工艺设计计算机仿真优化分析[J].特种铸造及有色合金,2018,38(05):497-500.

Xiang Tao. Design Optimization of ZL205A Frame Casting in Solidification Process. [J]. Special Casting & Nonferrous Alloys 38(5):497-500(2018)
[1]向涛.ZL205A副构架铸件凝固工艺设计计算机仿真优化分析[J].特种铸造及有色合金,2018,38(05):497-500. DOI： 10.15980/j.tzzz.2018.05.009.

Xiang Tao. Design Optimization of ZL205A Frame Casting in Solidification Process. [J]. Special Casting & Nonferrous Alloys 38(5):497-500(2018) DOI： 10.15980/j.tzzz.2018.05.009.

摘要

根据ZL205A铝合金副构架铸件结构与工艺特性

设计了底注式和侧注式浇注系统。采用华铸CAE软件对比分析了两种浇注工艺下凝固过程的温度场与缩孔、缩松分布。对缩孔、缩松产生原因进行了分析

优化了侧注式浇注系统

最终消除了铸件中的缩孔、缩松缺陷。ZL205A铝合金副构架本体试样经T5热处理后的平均抗拉强度、屈服强度、伸长率和硬度（HBS）分别为510 MPa、424 MPa、8.1%和131

达到了HB963-2005Ⅱ类铸件标准要求。

Abstract

The gravity filling process of the ZL205 Aframe casting was conducted by analyzing the structure and process characteristics

and the distribution of solidification temperature and shrinkage under two gravity filling process was simulated by the HUAZHU CAE software.The structure design optimization of the internal injection gating system was obtained through the process analysis of the origination of the shrinkage

and the shrinkage defects were eliminated effectively through adjusting the solidification sequence.The average tensile strength

yield strength

elongation and Brinell hardness of the castings reach 510 MPa

424 MPa

8.1% and 131 HBS

respectively

after the T5 heat treatment

which meets the HB962-2005Ⅱtechnical indicators.