Improvement of Adhesion Force of Heat Insulation Die Coating for Low-pressure Casting Aluminum Alloy Wheels

Wang Sen; Liao Weijun

doi:10.15980/j.tzzz.2017.11.015

Views : 0 下载量: 143 CSCD: 3

Export
Share
Collection
Album

Improvement of Adhesion Force of Heat Insulation Die Coating for Low-pressure Casting Aluminum Alloy Wheels
Vol. 37, Issue 11, Pages: 1215-1217(2017)
Published： 2017 ，
DOI： 10.15980/j.tzzz.2017.11.015

扫描看全文

[1]王森,廖卫军.低压铸造铝合金轮毂模具保温涂料附着力的改进[J].特种铸造及有色合金,2017,37(11):1215-1217.

Wang Sen, Liao Weijun. Improvement of Adhesion Force of Heat Insulation Die Coating for Low-pressure Casting Aluminum Alloy Wheels. [J]. Special Casting & Nonferrous Alloys 37(11):1215-1217(2017)
[1]王森,廖卫军.低压铸造铝合金轮毂模具保温涂料附着力的改进[J].特种铸造及有色合金,2017,37(11):1215-1217. DOI： 10.15980/j.tzzz.2017.11.015.

Wang Sen, Liao Weijun. Improvement of Adhesion Force of Heat Insulation Die Coating for Low-pressure Casting Aluminum Alloy Wheels. [J]. Special Casting & Nonferrous Alloys 37(11):1215-1217(2017) DOI： 10.15980/j.tzzz.2017.11.015.

摘要

针对铝合金轮毂低压铸造过程中由于模具涂料组成不合理、结构单一、容易脱落掉块或冲刷变薄甚至造成模具裸露

在全面分析现有涂料成分基础上

给出了改进措施。通过调整涂料组成并向其中引入晶须组分

结合适当的喷涂工艺

使铝合金轮毂低压铸造用保温涂料的使用效果得到明显改善

提高了轮毂成品率

降低了生产成本

有效提高了生产效率。

Abstract

The existing problems of heat insulating die coating for low-pressure casting aluminum alloy wheels were analyzed in order to improve the adhesion force of the coating.During the low-pressure casting process

because of its unreasonable composition and single structure

the existing die heat insulating coating is easily dropped off block or being scoured and worn thin

and even it takes metal die be exposed to the air and aluminum liquid.Improvement methods for the existing insulating die coating was presenetd on the basis of comprehensive analysis of its composition.By means of improving the composition and introducing potassium titanate whisker and combining suitable spray ways

casting production efficiency was promoted effectively

and yield product rate was improved and production cost was reduced.