Manufacture of a Typical Complex Thin-walled Aluminium Alloy Bracket

Zheng Weidong; Pan Junjie; Huang Yongqing; He Maoling; Wang Hailong; Wang Weikai

doi:10.15980/j.tzzz.2017.05.015

Views : 0 下载量: 194 CSCD: 1

Export
Share
Collection
Album

Manufacture of a Typical Complex Thin-walled Aluminium Alloy Bracket
Vol. 37, Issue 5, Pages: 512-514(2017)
Published： 2017 ，
DOI： 10.15980/j.tzzz.2017.05.015

扫描看全文

[1]郑卫东,潘俊杰,黄永庆,何茂领,王海龙,王卫凯.精密铸造复杂薄壁铝合金支架[J].特种铸造及有色合金,2017,37(05):512-514.

Zheng Weidong, Pan Junjie, Huang Yongqing, et al. Manufacture of a Typical Complex Thin-walled Aluminium Alloy Bracket. [J]. Special Casting & Nonferrous Alloys 37(5):512-514(2017)
[1]郑卫东,潘俊杰,黄永庆,何茂领,王海龙,王卫凯.精密铸造复杂薄壁铝合金支架[J].特种铸造及有色合金,2017,37(05):512-514. DOI： 10.15980/j.tzzz.2017.05.015.

Zheng Weidong, Pan Junjie, Huang Yongqing, et al. Manufacture of a Typical Complex Thin-walled Aluminium Alloy Bracket. [J]. Special Casting & Nonferrous Alloys 37(5):512-514(2017) DOI： 10.15980/j.tzzz.2017.05.015.

摘要

某典型复杂薄壁铝合金支架铸件采用ZL114A合金

基于支架铸件结构形状与铸造工艺难点分析

试验设计了熔模与石膏型复合型壳结合低压铸造成形工艺进行生产。结果表明

通过在铸件薄壁区域增设加强筋与排气条、优化低压充型及T6热处理参数

有效解决了薄壁支架铸件的浇不足、缩松等缺陷

生产出了高性能的合格铸件。

Abstract

A typical thin-walled complex bracket was produced with ZL114 Acasting alloy.Based on analysis of structure shape and casting difficulties of the bracket

composite investment shell mold and gypsum mold combined with low-pressure casting process was designed.The results reveal that by adding the enhanced rib and exhausted slot in thin-walled location of the bracket to optimizing parameters of low-pressure casting and T6 heat-treatment

misrun and shrinkage porosities in bracket can be elininated successfully

and the qualified bracket is produced successfully.