Temperature Field Analysis of Injection Mold for Trolley Trim Cover of the Automobile Based on ANSYS Software

Yue Shan; Chen Yan; Zhang Shuwei

doi:10.15980/j.tzzz.2017.04.008

Views : 0 下载量: 70 CSCD: 1

Export
Share
Collection
Album

Temperature Field Analysis of Injection Mold for Trolley Trim Cover of the Automobile Based on ANSYS Software
Vol. 37, Issue 4, Pages: 377-379(2017)
Published： 2017 ，
DOI： 10.15980/j.tzzz.2017.04.008

扫描看全文

[1]岳珊,陈焰,张淑伟.基于ANSYS的汽车拉杆装饰罩温度场分析[J].特种铸造及有色合金,2017,37(04):377-379.

Yue Shan, Chen Yan, Zhang Shuwei. Temperature Field Analysis of Injection Mold for Trolley Trim Cover of the Automobile Based on ANSYS Software. [J]. Special Casting & Nonferrous Alloys 37(4):377-379(2017)
[1]岳珊,陈焰,张淑伟.基于ANSYS的汽车拉杆装饰罩温度场分析[J].特种铸造及有色合金,2017,37(04):377-379. DOI： 10.15980/j.tzzz.2017.04.008.

Yue Shan, Chen Yan, Zhang Shuwei. Temperature Field Analysis of Injection Mold for Trolley Trim Cover of the Automobile Based on ANSYS Software. [J]. Special Casting & Nonferrous Alloys 37(4):377-379(2017) DOI： 10.15980/j.tzzz.2017.04.008.

摘要

模具温度分布的均匀性是影响汽车注塑制品质量的重要因素

约60%的塑件缺陷是由模具冷却系统设计不当造成的。针对汽车拉杆装饰罩注塑件缺陷部位

建立了塑件缺陷部位瞬态温度场数学模型及求解的边界条件和初始条件

利用ANSYS有限元软件进行分析仿真。结果表明

塑件表面温度为141.7℃

中心温度为229.1℃

温度差高达87.4℃

不满足塑件要求。据此

重新设计布局模具冷却系统结构。保持注塑工艺条件不变

连续抽样3 000件

合格率为100%。

Abstract

The uniformity of mold temperature distribution is the important factor affecting the quality of automotive injection products

and 60% plastics product’s defects are caused by mold cooling system as a result of un-suitable design.Due to the trolley trim cover defects

the mathematical model was established

and boundary and initial conditions were taken into account to analyze the temperature field of defects positions based on the ANSYS software.The results show that the surface temperature and center temperature reach 141.7℃and 229.1℃

respectively

so temperature difference reaches up to 87.4℃

which is not meet the requirements of plastics.The cooling system structure of the mold was re-designed.At the same injection conditions

continuous samples 3 000 products show 100% qualified rate.