Numerical Simulation and Processing Optimization of Steel Casting Beam by Sand Casting

Liu Chen; Mi Guofa; Wang Youchao; Xu Lei; Li Changyun

doi:10.15980/j.tzzz.2016.12.008

Views : 0 下载量: 288 CSCD: 1

Export
Share
Collection
Album

Numerical Simulation and Processing Optimization of Steel Casting Beam by Sand Casting
Vol. 36, Issue 12, Pages: 1266-1269(2016)
Published： 2016 ，
DOI： 10.15980/j.tzzz.2016.12.008

扫描看全文

[1]刘晨,米国发,王有超,许磊,历长云.横梁铸钢件砂型铸造数值模拟及工艺优化[J].特种铸造及有色合金,2016,36(12):1266-1269.

Liu Chen, Mi Guofa, Wang Youchao, et al. Numerical Simulation and Processing Optimization of Steel Casting Beam by Sand Casting. [J]. Special Casting & Nonferrous Alloys 36(12):1266-1269(2016)
[1]刘晨,米国发,王有超,许磊,历长云.横梁铸钢件砂型铸造数值模拟及工艺优化[J].特种铸造及有色合金,2016,36(12):1266-1269. DOI： 10.15980/j.tzzz.2016.12.008.

Liu Chen, Mi Guofa, Wang Youchao, et al. Numerical Simulation and Processing Optimization of Steel Casting Beam by Sand Casting. [J]. Special Casting & Nonferrous Alloys 36(12):1266-1269(2016) DOI： 10.15980/j.tzzz.2016.12.008.

摘要

运用常规的铸造工艺设计方法对铸钢件横梁的铸造工艺进行初步的设计

利用View Cast软件对初始工艺的凝固过程进行了数值模拟

分析原始工艺产生缺陷的部位和原因。在此基础上

通过改进冒口、冷铁等铸造工艺参数

优化了铸造工艺

并对优化后的工艺再次进行模拟。结果显示

优化后的工艺能够平稳而有序的充型

实现了顺序凝固

可以较大程度地减少缩孔、缩松等铸造缺陷。根据该工艺方案进行实际浇注

铸件品质大幅提高

其内部组织及力学性能均达到或高于技术要求。

Abstract

The initial casting process of steel casting beam was designed by conventional method.The solidification process of initial casting was simulated by the View Cast software.The location and origination of shrinkage porosities in the initial casting process were analyzed.Based on the above analysis

through adding chilling iron and using insulating riser

the casting process was optimized and simulated again.The results show that the optimized process can fill smoothly and orderly

realizing sequential solidification and eliminating shrinkage and porosity mostly.According to the optimized process for actual production

the casting quality is improved greatly

and microstructure and mechanical properties meet the requirement.