Design of Divided-Body Mould for Investment Casting Impeller Based on UG Software

Views : 0 下载量: 129 CSCD: 7

Design of Divided-Body Mould for Investment Casting Impeller Based on UG Software
Vol. 36, Issue 10, Pages: 1077-1079(2016)
Published： 2016 ，
DOI： 10.15980/j.tzzz.2016.10.019

扫描看全文

[1]刘雅芸,黄放,崔晓斌,廖兴银.基于UG的叶轮分体式熔模铸造的模具设计[J].特种铸造及有色合金,2016,36(10):1077-1079.

Liu Yayun, Huang Fang, Cui Xiaobin, et al. Design of Divided-Body Mould for Investment Casting Impeller Based on UG Software. [J]. Special Casting & Nonferrous Alloys 36(10):1077-1079(2016)
[1]刘雅芸,黄放,崔晓斌,廖兴银.基于UG的叶轮分体式熔模铸造的模具设计[J].特种铸造及有色合金,2016,36(10):1077-1079. DOI： 10.15980/j.tzzz.2016.10.019.

Liu Yayun, Huang Fang, Cui Xiaobin, et al. Design of Divided-Body Mould for Investment Casting Impeller Based on UG Software. [J]. Special Casting & Nonferrous Alloys 36(10):1077-1079(2016) DOI： 10.15980/j.tzzz.2016.10.019.