Lost Foam Casting Deep Pine Shovel Tip

Views : 0 下载量: 87 CSCD: 1

扫描看全文

[1]唐喜乐,曲迎东,姜珂,尤俊华.深松铲尖消失模铸造工艺的研究[J].特种铸造及有色合金,2016,36(08):838-840.

Tang Xile, Qu Yingdong, Jiang Ke, et al. Lost Foam Casting Deep Pine Shovel Tip. [J]. Special Casting & Nonferrous Alloys 36(8):838-840(2016)
[1]唐喜乐,曲迎东,姜珂,尤俊华.深松铲尖消失模铸造工艺的研究[J].特种铸造及有色合金,2016,36(08):838-840. DOI： 10.15980/j.tzzz.2016.08.016.

Tang Xile, Qu Yingdong, Jiang Ke, et al. Lost Foam Casting Deep Pine Shovel Tip. [J]. Special Casting & Nonferrous Alloys 36(8):838-840(2016) DOI： 10.15980/j.tzzz.2016.08.016.

分析了深松铲尖消失模铸造与金属型铸造、砂型铸造的不同

并优化了消失模铸造深松铲尖的工艺参数。另外

采用ProCAST软件

对消失模铸造深松铲尖工艺进行数值模拟

确定了深松铲尖消失模铸造的合理工艺参数

珠粒预发泡密度为20

4g/L

负压为-0.05

0.06 MPa

保压时间为5min

得到的铸件铸态硬度（HRC）为51

耐磨性较好。

The difference of casting technologies for deep pine shovel tip among lost foam casting

the iron based coated sand

the sand mold was analyzed.Lost foam casting for deep pine shovel tip was designed and simulated by ProCAST software.Then

optimized parameters of lost foam casting were presented as follows:bead density of 20

4g/L

vacuum rate of-0.05

0.06 MPa for 5 min during pouring process.The casting hardness of deep pine shovel tip reaches up to 51 HRC

exhibiting the satisfied wear resistance.

深松铲尖消失模铸造数值模拟耐磨性

Deep Pine Shovel TipLost Foam CastingNumerical SimulationWear Resistence

Alert me when the article has been cited

提交