Optimization of Die Casting Mould of the Aluminum Alloy Connected Sleeve Based on the ProCAST Software

Zhou Xiang; Ding Lin

doi:10.15980/j.tzzz.2016.08.011

Views : 0 下载量: 155 CSCD: 1

Export
Share
Collection
Album

Optimization of Die Casting Mould of the Aluminum Alloy Connected Sleeve Based on the ProCAST Software
Vol. 36, Issue 8, Pages: 822-825(2016)
Published： 2016 ，
DOI： 10.15980/j.tzzz.2016.08.011

扫描看全文

[1]周香,丁林.基于ProCAST的铝合金连接套压铸模具及工艺优化[J].特种铸造及有色合金,2016,36(08):822-825.

Zhou Xiang, Ding Lin. Optimization of Die Casting Mould of the Aluminum Alloy Connected Sleeve Based on the ProCAST Software. [J]. Special Casting & Nonferrous Alloys 36(8):822-825(2016)
[1]周香,丁林.基于ProCAST的铝合金连接套压铸模具及工艺优化[J].特种铸造及有色合金,2016,36(08):822-825. DOI： 10.15980/j.tzzz.2016.08.011.

Zhou Xiang, Ding Lin. Optimization of Die Casting Mould of the Aluminum Alloy Connected Sleeve Based on the ProCAST Software. [J]. Special Casting & Nonferrous Alloys 36(8):822-825(2016) DOI： 10.15980/j.tzzz.2016.08.011.

摘要

用Pro/E软件对连接套零件及浇注系统进行三维建模

选取一组初始工艺参数

采用ProCAST软件分别对带有两种不同浇注系统的连接套三维模型进行网格划分、模拟充型及凝固过程模拟

预测铸件缩孔、缩松缺陷可能出现的位置

据此确定浇注系统位置。

Abstract

3D model of the connected sleeve with gating system was established by Pro/E software.Through selecting a set of parameters

separately meshing the connected sleeve with two different gating system of 3D model

the possible locations of shrinkage cavity were predicted effectively during the filling and solidification process.According to the simulated results

the location of gating system was presented.