Simulation and Experimental Research of Electromagnetic Stirring Technology in Manganese Alloy Forming

Cui Jinghua; Wang Huizhen; Zhi Yuerong

doi:10.15980/j.tzzz.2016.01.030

Views : 0 下载量: 81 CSCD: 0

Export
Share
Collection
Album

Simulation and Experimental Research of Electromagnetic Stirring Technology in Manganese Alloy Forming
Vol. 36, Issue 1, Pages: 110-112(2016)
Published： 2016 ，
DOI： 10.15980/j.tzzz.2016.01.030

扫描看全文

[1]崔京华,王惠贞,支月蓉.电磁搅拌技术在锰合金成形中的仿真及试验[J].特种铸造及有色合金,2016,36(01):110-112.

Cui Jinghua, Wang Huizhen, Zhi Yuerong. Simulation and Experimental Research of Electromagnetic Stirring Technology in Manganese Alloy Forming. [J]. Special Casting & Nonferrous Alloys 36(1):110-112(2016)
[1]崔京华,王惠贞,支月蓉.电磁搅拌技术在锰合金成形中的仿真及试验[J].特种铸造及有色合金,2016,36(01):110-112. DOI： 10.15980/j.tzzz.2016.01.030.

Cui Jinghua, Wang Huizhen, Zhi Yuerong. Simulation and Experimental Research of Electromagnetic Stirring Technology in Manganese Alloy Forming. [J]. Special Casting & Nonferrous Alloys 36(1):110-112(2016) DOI： 10.15980/j.tzzz.2016.01.030.

摘要

采用Maxwell 2D软件对电磁搅拌器的磁场进行仿真

得到电磁搅拌器的磁力线的分布几乎都在磁场发生器绕组周围

此处的磁感应强度最大

并确定搅拌频率为40Hz时可取得较好的效果。根据仿真结果

搭建了合金电磁搅拌成形试验装置

研究了锰合金的微观组织和性能。结果表明

电磁搅拌技术能够改善锰合金的微观组织;通过观察不同冷却时间和冷却速率条件下的裂纹数

发现当冷却时间为自然冷却所需时间的1/3%

/4%时

锰合金的组织与性能理想。

Abstract

The magnetic field of electromagnetic stirrer was simulated by the Maxwell 2Dsoftware.The results indicate that the magnetic field lines are distributed almost around the magnetic field generator windings

and the largest magnetic induction intensity can be observed.And the reasonable current frequency is 40 Hz.The electromagnetic stirring forming apparatus for the alloy was designed on the basis of the simulated results

and the microstructure and properties of manganese alloy were investigated.The results reveal that the electromagnetic stirring technique can improve the microstructure of manganese alloy.By observing crack number in the alloy at different cooling time and cooling rate

the microstructure and properties of the Mn alloy exhibit desirable with cooling at a third-quarter natural cooling time.