Optimization Design of Casting Process for Aluminum Alloy Impeller

Yang Huanqing; Sun Fei; Wang Lin; Yin Yajun

doi:10.15980/j.tzzz.2014.06.004

Views : 0 下载量: 204 CSCD: 1

Export
Share
Collection
Album

Optimization Design of Casting Process for Aluminum Alloy Impeller
Vol. 34, Issue 6, Pages: 570-573(2014)
Published： 2014 ，
DOI： 10.15980/j.tzzz.2014.06.004

扫描看全文

[1]杨欢庆,孙飞,王琳,殷亚军.铝合金叶轮铸造工艺优化设计[J].特种铸造及有色合金,2014,34(06):570-573.

Yang Huanqing, Sun Fei, Wang Lin, et al. Optimization Design of Casting Process for Aluminum Alloy Impeller. [J]. Special Casting & Nonferrous Alloys 34(6):570-573(2014)
[1]杨欢庆,孙飞,王琳,殷亚军.铝合金叶轮铸造工艺优化设计[J].特种铸造及有色合金,2014,34(06):570-573. DOI： 10.15980/j.tzzz.2014.06.004.

Yang Huanqing, Sun Fei, Wang Lin, et al. Optimization Design of Casting Process for Aluminum Alloy Impeller. [J]. Special Casting & Nonferrous Alloys 34(6):570-573(2014) DOI： 10.15980/j.tzzz.2014.06.004.

摘要

铝合金叶轮铸件厚薄不均、结构复杂

在铸件内部易于产生微观缩松。结合实际生产条件

对铝合金叶轮铸件原工艺进行了充型凝固过程模拟

通过对流动形态、凝固顺序及缩松、缩孔缺陷的分析

并与实际铸件进行对比

得到了原工艺缺陷产生的原因。在此基础上

利用华铸CAE软件对铝合金叶轮铸件进行了工艺优化分析

获得了较优的工艺方案

并进行了实际浇注验证。结果表明

优化工艺后

有效减少直至消除了铸件的缩孔、缩松缺陷。

Abstract

Microscopic shrinkage is easy to generate in the aluminum alloy impeller as a result of uneven thickness and complicated design structure.Combining with the actual production conditions

filling and solidification process of initial design for aluminum alloy impeller were simulated.Through analyzing flow morphology

the solidification sequence and shrinkage porosities

and comparing with actual produced impeller

origination of defects in the original process was presented.Based on the above mentioned results

using InteCAST software

casting process optimization for aluminum alloy impeller was conducted

and a optimized design was presented.The actual impeller was produced to verify the availability of the simulated results.The results show that the optimized design can reduce effectively the shrinkage porosity（choles）in the castings.