Influence of Stirring Parameters on SiCp Distribution in SiC<sub>p</sub>/AZ31 Composite

Tang Meng’ou; Zhang Zhifeng; Xu Jun; Yang Bicheng; Liu Guojun; Bai Yuelong; Li Bao

doi:10.15980/j.tzzz.2013.04.005

Views : 0 下载量: 211 CSCD: 4

Export
Share
Collection
Album

Influence of Stirring Parameters on SiCp Distribution in SiC_p/AZ31 Composite
Vol. 33, Issue 4, Pages: 295-298(2013)
Published： 2013 ，
DOI： 10.15980/j.tzzz.2013.04.005

扫描看全文

[1]汤孟欧,张志峰,徐骏,杨必成,刘国钧,白月龙,李豹.搅拌工艺对SiC_p/AZ31复合材料颗粒分布的影响[J].特种铸造及有色合金,2013,33(04):295-298.

Tang Meng’ou, Zhang Zhifeng, Xu Jun, et al. Influence of Stirring Parameters on SiCp Distribution in SiC_p/AZ31 Composite. [J]. Special Casting & Nonferrous Alloys 33(4):295-298(2013)
[1]汤孟欧,张志峰,徐骏,杨必成,刘国钧,白月龙,李豹.搅拌工艺对SiC_p/AZ31复合材料颗粒分布的影响[J].特种铸造及有色合金,2013,33(04):295-298. DOI： 10.15980/j.tzzz.2013.04.005.

Tang Meng’ou, Zhang Zhifeng, Xu Jun, et al. Influence of Stirring Parameters on SiCp Distribution in SiC_p/AZ31 Composite. [J]. Special Casting & Nonferrous Alloys 33(4):295-298(2013) DOI： 10.15980/j.tzzz.2013.04.005.

摘要

采用搅拌铸造法制备了SiCp/AZ31复合材料

研究了搅拌速度、搅拌时间对复合材料孔隙率和颗粒分布的影响。针对搅拌铸造工艺加入增强体含量有限的缺陷

研究了一种制备高SiCp含量AZ31镁基复合材料的分级搅拌工艺。结果表明

分级搅拌工艺制备的复合材料SiCp含量为25%

颗粒分布标准偏差小于0.1。

Abstract

The SiCp/AZ31 composites were prepared by stirring casting

and effects of stirring speed and stirring time on porosity and particle distribution in the composites prepared was investigated. The experimental results show that the process parameters

such as stirring speed

stirring time

have a marked influence on the distribution of SiCp in MMC. A method called graded stirring is proposed to overcome the low reinforcement content. Magnesium matrix composites containing 25%SiC particles with standard distribution error lower than 0.1 can be prepared successfully by the graded stirring process.