Microstructure and Mechanical Properties of Mg-1Er-0.6Zr

Views : 0 下载量: 59 CSCD: 1

扫描看全文

[1]罗建华,张文玉.Mg-1Er-0.6Zr合金的显微组织和力学性能[J].特种铸造及有色合金,2012,32(09):789-792.

Luo Jianhua, Zhang Wenyu. Microstructure and Mechanical Properties of Mg-1Er-0.6Zr. [J]. Special Casting & Nonferrous Alloys 32(9):789-792(2012)
[1]罗建华,张文玉.Mg-1Er-0.6Zr合金的显微组织和力学性能[J].特种铸造及有色合金,2012,32(09):789-792. DOI： 10.15980/j.tzzz.2012.09.012.

Luo Jianhua, Zhang Wenyu. Microstructure and Mechanical Properties of Mg-1Er-0.6Zr. [J]. Special Casting & Nonferrous Alloys 32(9):789-792(2012) DOI： 10.15980/j.tzzz.2012.09.012.

采用金相显微镜、扫描电镜及能谱分析等手段

研究了Mg-1Er-0.6Zr合金在铸态、挤压态和时效态的室温组织和力学性能。结果表明

在温度为300℃

挤压比为16:1时

合金的抗拉强度、屈服强度和伸长率分别为206.5MPa、78.5MPa和25%

比铸态时分别提高了28.4%、8.6%和150%。挤压后时效处理

强度稍有提高;但固溶后再时效其强度明显降低

塑性也有所降低。

Microstructure and mechanical properties of Mg-1Er-0.6Zr alloys in as-cast

extruded and aged state were investigated by means of optical microscope（OM）

scanning electron microscope（SEM）and energy spectrum analysis（EDS）.The results show that the tensile strength

yield strength and elongation of as-extrued Mg-1Er-0.6Zr alloy at 300 ℃ with extrusion ratio of 16 reach 206.5 MPa

78.5 MPa and 25%

respectively

improved by 28%

8% and 150%

comparing to those of the as-cast alloy.The strength of the extruded alloy after aging treatment is increased slightly

however

it is greatly decreased after solid solution with re-aging treatment

and elongation is decreased slightly also.

Mg-Er-Zr合金显微组织力学性能

Mg-Er-Zr AlloyMicrostructureMechanical Properties

Alert me when the article has been cited

提交