CAE Analysis of Overflow System for Die-Casting Oil-Filter Seat

Zhang Yangyang; Liu Jing; Wang Zhonghou; Wang Qiaoling

doi:10.15980/j.tzzz.2012.08.022

Views : 0 下载量: 73 CSCD: 2

Export
Share
Collection
Album

CAE Analysis of Overflow System for Die-Casting Oil-Filter Seat
Vol. 32, Issue 8, Pages: 736-739(2012)
Published： 2012 ，
DOI： 10.15980/j.tzzz.2012.08.022

扫描看全文

[1]张扬扬,刘静,汪中厚,王巧玲.机油滤清器座压铸件溢流系统的CAE分析[J].特种铸造及有色合金,2012,32(08):736-739.

Zhang Yangyang, Liu Jing, Wang Zhonghou, et al. CAE Analysis of Overflow System for Die-Casting Oil-Filter Seat. [J]. Special Casting & Nonferrous Alloys 32(8):736-739(2012)
[1]张扬扬,刘静,汪中厚,王巧玲.机油滤清器座压铸件溢流系统的CAE分析[J].特种铸造及有色合金,2012,32(08):736-739. DOI： 10.15980/j.tzzz.2012.08.022.

Zhang Yangyang, Liu Jing, Wang Zhonghou, et al. CAE Analysis of Overflow System for Die-Casting Oil-Filter Seat. [J]. Special Casting & Nonferrous Alloys 32(8):736-739(2012) DOI： 10.15980/j.tzzz.2012.08.022.

摘要

以ADC12机油滤清器座为研究对象

使用分析软件Flow-3D

研究溢流系统总体积与铸件的总体积的比值关系。结果表明

溢流系统设计的大小及位置对充填过程影响很大。当溢流系统总体积占铸件总体积29%时

铸件中的卷气、氧化物等明显减少。

Abstract

Ratio between the total volume of overflow system and the total volume of the ADC12 die casting oil-filter seat was analyzed by the Flow-3D software.The results show that the size and position of the overflow system are closely related with die-casting filling

and gas-entrapment and oxides in the oil-filter seat can be reduced significantly when the volume of the overflow system is 29% of the total castings volume.