Process Simulation of Vacuum Die Casting Magnesium Alloy Steering Gear Process

Rao Lei1; Zhu Lianbing2; Liu Yong2; Hu Qiyao2

doi:10.15980/j.tzzz.2012.07.033

Views : 0 下载量: 146 CSCD: 3

Export
Share
Collection
Album

Process Simulation of Vacuum Die Casting Magnesium Alloy Steering Gear Process
Vol. 32, Issue 7, Pages: 637-640(2012)
Published： 2012 ，
DOI： 10.15980/j.tzzz.2012.07.033

扫描看全文

[1]饶磊,朱炼兵,刘勇,胡启耀.镁合金转向器铸件真空压铸过程的模拟研究[J].特种铸造及有色合金,2012,32(07):637-640.

Rao Lei1, Zhu Lianbing2, Liu Yong2, et al. Process Simulation of Vacuum Die Casting Magnesium Alloy Steering Gear Process. [J]. Special Casting & Nonferrous Alloys 32(7):637-640(2012)
[1]饶磊,朱炼兵,刘勇,胡启耀.镁合金转向器铸件真空压铸过程的模拟研究[J].特种铸造及有色合金,2012,32(07):637-640. DOI： 10.15980/j.tzzz.2012.07.033.

Rao Lei1, Zhu Lianbing2, Liu Yong2, et al. Process Simulation of Vacuum Die Casting Magnesium Alloy Steering Gear Process. [J]. Special Casting & Nonferrous Alloys 32(7):637-640(2012) DOI： 10.15980/j.tzzz.2012.07.033.

摘要

针对汽车镁合金转向器铸件

采用数值模拟的方法研究了其真空压铸成形过程

分析了在高真空度条件下金属液充型的特点

并在此基础上对比研究了在高真空度、低真空度以及常压条件下充型及凝固的规律。结果表明

提高型腔真空度能有效地提高金属液充型能力

避免铸件内气孔的产生

但对缩孔、缩松缺陷的形成没有影响。

Abstract

Filling process of vacuum die casting magnesium alloy steering gear was simulated by numerical simulation to understand the filling characteristics of liquid metal under the high vacuum conditions.Based on the simulated results

the filling and solidification of the alloy at high vacuum

low vacuum and conventional die casting were analyzed comparatively.The results show that filling capacity of liquid metal can be improved effectively with increasing in the vacuum degree

eliminating the gas hole defects in the steering gear

however

it is not related to the shrinkage porosity（hole）.