Indirect Squeeze Casting Technology for Bearing Holder

Hu Jianhua Luo Jixiang

doi:10.15980/j.tzzz.2000.s1.015

Views : 0 下载量: 47 CSCD: 5

Export
Share
Collection
Album

Indirect Squeeze Casting Technology for Bearing Holder
Issue S1, Pages: 49-50(2000)
Published： 2000 ，
DOI： 10.15980/j.tzzz.2000.s1.015

扫描看全文

[1]胡建华,罗继相.轴承保持器间接挤压铸造工艺[J].特种铸造及有色合金,2000(S1):49-50.

Hu Jianhua Luo Jixiang. Indirect Squeeze Casting Technology for Bearing Holder. [J]. Special Casting & Nonferrous Alloys (S1):49-50(2000)
[1]胡建华,罗继相.轴承保持器间接挤压铸造工艺[J].特种铸造及有色合金,2000(S1):49-50. DOI： 10.15980/j.tzzz.2000.s1.015.

Hu Jianhua Luo Jixiang. Indirect Squeeze Casting Technology for Bearing Holder. [J]. Special Casting & Nonferrous Alloys (S1):49-50(2000) DOI： 10.15980/j.tzzz.2000.s1.015.

摘要

研究了轴承保持器的间接挤压铸造工艺 ;分析了模具的结构特点 ;确定了合理的液态模锻工艺参数。结果表明 :挤压铸造铝合金轴承保持器完全满足使用要求

可替代铜合金产品

Abstract

Indirect squeeze casting technology for bearing holder is studied.Structural features of die are analyzed and reasonable technological parameters for liquid forging are determined.The results show that Al alloy bearing holder by squeeze casting can meet the performance requirement greatly and displace Cu alloy holder