Effect of Sulfur  Silicon Content on High Duty  Cast Iron with High Sulfur Content

Chen Huimin  Zhou Xiaoping  Wang Hongbin  Li Sinian\ Chen qin

Views : 0 下载量: 31 CSCD: 1

Export
Share
Collection
Album

Effect of Sulfur Silicon Content on High Duty Cast Iron with High Sulfur Content
Issue 1, (1997)
Published： 1997 ，
DOI：

扫描看全文

[1]陈慧敏,周小平,汪宏斌,李四年,陈菁.高硫高强铸铁金属型铸造中S─Si的作用[J].特种铸造及有色合金,1997(01):13-15.

Chen Huimin Zhou Xiaoping Wang Hongbin Li Sinian\ Chen qin. Effect of Sulfur Silicon Content on High Duty Cast Iron with High Sulfur Content. [J]. Special Casting & Nonferrous Alloys (1).(1997)
[1]陈慧敏,周小平,汪宏斌,李四年,陈菁.高硫高强铸铁金属型铸造中S─Si的作用[J].特种铸造及有色合金,1997(01):13-15. DOI：

Chen Huimin Zhou Xiaoping Wang Hongbin Li Sinian\ Chen qin. Effect of Sulfur Silicon Content on High Duty Cast Iron with High Sulfur Content. [J]. Special Casting & Nonferrous Alloys (1).(1997) DOI：

摘要

研究了高硫高强铸铁金属型铸造时，硫对白口化的作用和Ｓ／Ｓｉ值对退火时间及石墨形态的影响。结果表明合适的硅硫含量各为Ｓｉ＝２．０％～２．５％，Ｓ＝０．２％～０．４％，Ｓ／Ｓｉ＞０．１。指出了Ｓ／Ｍｎ值对石墨形态的重要作用，论述了硫的作用机理

Abstract

Effect of sulfur on chilling tendency and S/Si ratio on annealing time and graphite morphology for high duty cast iron with high sulfur content in metallic mould was studied. Experimental results indicated that the appropriate sulfur silicon contents were S=0.2%￣0.4%

Si=2.0%￣2.5%

S/Si>0.1. It was suggested that S/Mn played important role for graphite morphology. The mechanism of sulfur effect was discussed.

关键词

硫S／Si白口化金属型石墨化退火

Keywords

SulfurS/Si RatioChilling TendencyMetallic MouldGraphitizing Annealing

references

Alert me when the article has been cited

提交

Development and Application of the Coatings for Gravity Die Casting and Low Pressure Casting